1. To meet the requirements of lead-free solder design;

2. The tip forms, you can quickly solve difficult soldering process;

3. Built-in high-precision thermocouples, low temperature drop can be quickly detected and restored;

4.6 seconds to reach 300 ° C;

5. The cartridge design of the tip can be quickly replaced easily and conveniently, DCS series series tip-one design, can save 50% of the cost of supplies.

6. Scope wide: clutch parts welding, soldering micro switch, PCB soldering ceramic parts, the substrate and the fixed parts, GPS circuit board welding, high brightness LED welding, wire welding, 90-degree corners welding, FPCB parts welding, spot welding precision connectors pull welding, welding cable, PIN foot welding, wire welding in FPCB, buzzer connector, FPBC pull welding, FPCB spot welding, soft plate welding, TAB pull welding.

7. Enthone passers Technology Co., Ltd. supply full range of models tip, welcome customized for their own products. (Customized product delivery: 4-10 days)

8. The factory own customers have free samples tested. 

1. Since the solder melting temperature is quite high (300° above), please be careful, do not touch the spills with your skin;After using, please note that iron will remain hot, once burn occurs, seek immediate medical attention.Smoke or steam generated during soldering operations

2. Direct inhalation and longterm sustained inhalation may cause headaches and other health problems;A large number of suction will be one of the causes of pulmonary edema;Please stay in long-term ventilation ventilated places When Soldering work?Please carefully note

3. When soldering working, do not steam flux and solder direct contact with the skin;Please use protective equipment as required, due to the flux adhesion can cause inflammation of the skin, immediately rinse with water; If into the eyes, pls wash immediately with clean water, if necessary, seek immediate medical attention. If attached to the top of clothing, please be fully cleaned 

We maintain high standards of excellence and strive for 100% customer satisfaction! Feedback is very important We request that you contact us immediately BEFORE you give us neutral or negative feedback, so that we can satisfactorily address your concerns.