HN-YC series tuning fork level meter

HN-YC series tuning fork level meter
Model:HN-YC
Brand:Harhn
Origin:Made In China
Category:Electronics & Electricity / Electronic Instrument / Air & Gas Flowmeter
Label:fork level
Price: ¥1500 / pc
Min. Order:1 pc
Inquire Now

Product Description

Tuning fork level meter Description:
    HN-YC series tuning fork level sender is in our original series H-YC tuning fork Level sender on the basis of major technological improvements produced by the new generation of products. With advanced integrated circuit, a good product mix and manufacturing standards. Its performance to achieve the advanced level of similar foreign products.


HN-YC series tuning fork level meter

Working principle and structure

Level sensor portion of this product is based on the work of the tuning fork principle. Tuning fork is driven by the weak energy will be able to cause resonance elastic body, when it is subject to material damping effect drastically reduced amplitude and frequency, and phase change significantly, by an electronic circuit with a tuning fork vibration excitation piezoelectric ceramic element and the output switching signal. The working principle block diagram shown in Figure.
[Map]
 
HN-YC series tuning fork level sender from the cross on sound body, a piezoelectric element, a circuit board, to take over the flange and shell and other components.

Feature

 - Structure, small size, reliable work.
 - Looper flange, easy to install.
 - Suitable for any shape, material hopper
 - Electrical properties affected by the tested material.
 - Anti-dirt and strong, as long as two prongs room without completely blocking, the instrument can still work.
 - There are a variety of signal outputs in the form of options.

Normal working conditions:
1. Operating temperature:
   Sensor parts: common type: -20 ℃ ~ + 80 ℃
   High temperature: -20 ℃ ~ + 200 ℃
   Circuit portion: -20 ℃ ~ + 70 ℃
2. Relative humidity: 5 to 100%
3. Atmospheric pressure: 86 ~ 108KPa
4. Environmental vibration level: V L 4 acceleration ≤1g??
5. Power supply voltage: AC: 220V ± 10% 50Hz ~ 60Hz
6. Working pressure: 1MPa
7. Angle of repose of the material medium:> 20 °
8. Materials Medium Density: Liqui t; 0.7g / cm3; Soli t; 0.1g / cm3
9. Material particle size: ≯15mm
:( Medium viscosity liquid material 10) <1000mm2 / s

Technical characteristics:

1. Sensor sensitivity adjustable
2. Switching signal delay time (bidirectional): 1 ~ 10s (adjustable)
3. Switch state (normally open or normally closed) can be any conversion
4. Constant current output:? 0 ~ 10mA DC (non-grounded type, and synchronization with the sensor)
5. Current precision: ≤0.5% (F S?)
6. Solid state relay output voltage: AC Type: 24V ~ 240V, 1A; DC type: 5V ~ 220V, 1A
7. High-temperature sensors and circuit portion maximum separation distance: ≤50m
8. There are lights display: green light indicates that the sensor working, red light indicates the relay is switched on.
9. Power Consumption: ≤2VA
10. Shell protection grade: IP65

Purpose and Scope:

    HN-YC series of products for various openings or the inner pressure vessel level detection, alarm or digital control, with sound and light alarm device or connected to a computer monitoring system, and I can also plant the production of UZC controller fit, UZC or use within the non-contact switch relay (SSR) direct control of pumps, valves, motors and other equipment, material level automatic control. Teflon-treated by anti-corrosion product release, contact material portion having equivalent PTFE corrosion resistance and good anti-adhesion properties of materials can be used in a certain corrosive and viscous material level measurement.
    Long products applicable to the vessel wall is very thick, or the top of the container for mounting vertically downward.
    Separate type of material used for the measured temperature exceeds the specified range (-20 ~ 80 ℃) level detection, such products fork and partial separation of the circuit box. To ensure that the circuit portion under normal ambient temperatures, the separation distance should be less than 20m.
    Product is suitable for high-temperature material temperature level detection in the range of -20 ~ 200 ℃.
    Separate product is suitable for longer and longer applicable separate common level detection.
    Long product is suitable for high-temperature and high-temperature longer applicable common level detection.


If unknown: please contact customer service

Payment Terms:TT
HN-YC series tuning fork level meter 1HN-YC series tuning fork level meter 2HN-YC series tuning fork level meter 3HN-YC series tuning fork level meter 4HN-YC series tuning fork level meter 5

Member Information

HarHn (DaLan)Fluid control Technology Co.,Ltd
Country/Region:Liao Ning - China
Business Nature:Manufacturer
Phone:13842856816
Contact:ouyang (Sales Manager)
Last Online:21 Apr, 2021