> Tool is easily removed,by sliding sideways after winding has been completed.

> Place band around boot and through nose of tool and through slot in winding body.

> Using a 1/2"socket wrench or by hand wind the band until sufficient tension is applied.

> Rotate handle over the boot to lock the band.

> Slide tool free-end down with a hammer.1.Wrap free-end clamps 3/8"or 1/4"roll band and clip around boot.thread the band throuth the clip.into the nose of the tool and through the winding mandrel slot.2.Place a 1/2"ratchet wrench on the winding mandrel and turn.when sufficient tension has been applied,ratate the tool over the boot,bending the band back onto the clip.3.It applies tension and has a built-in cutter.4.To complete clamping,fold down the remaining tail of the band into the clip and secure it by tapping down the ears of the clip.