We hold immense expertise in this domain for manufacturing, supplying and exporting Cone Crusher. Suitable for crushing limestone, granite, road aggregate with fast speed, these crushers are widely used in construction and engineering industries. Developed in compliance with industrial standards using cutting-edge technology, we are offering these crushers in wide range of specifications. The demand of our Cone Crusher is increasing at a rapid pace as these are easy to use, sturdy in construction and require minimum maintenance.

A cone crusher is generally used as a secondary crusher in a crushing circuit.  Pre-crushed product is fed through the top of the cone crusher and flows over the mantle.  The vertical cone crusher drive shaft rotates the mantle eccentrically below the concave, or bowl liner, squeezing the product and crushing it between the mantle and concave.  Cone crushers are usually run on belt drives driven by an electric motor or diesel engine.  Cone crushers are used extensively throughout the aggregate and mineral processing industry. 

Type: Secondary Crushing

Input Size: 40-350MM

Features:

1. The spring cone crushers crushes by the change of the gap in the crushing cavity;

2. High reduction ratio, high performance, low power consumption, and uniform size products.

Working Principle：Cone crusher crushes materials by the working surface between the movable cone and fixed cone. The movable cone of the cone crusher is supported by spherical bearing and fixed on an hanging erect shaft which is set in the eccentric sleeve, and the sleeve is set on the stopping and pushing bearing. The movable cone and erect shaft are drived by the eccentric shaft sleeve together. The eccentric shaft sleeve is driven by horizontal shaft and fimbriated gear, and the wheel of the conveyor belt is drived by motor through v-belts.The lower part of vertical shaft is installed in the eccentric sleeve. When the eccentric sleeve of cone crusher rotates, there is a conical surface lined out by the shaft. When the movable cone comes near the fixed cone, rocks are grinded into pieces, when the cone leaves, grinded materials is discharged from the diacharge hole. The fixed cone can be ascended or descended by adjusting setting to adjust the width of discharge hole, consequantly the output size is determined.

Learn more at:

http://www.micrusher.com/index.html
http://www.kelmachine.com/index.html
http://qhclmy.com/

Leave a message:lmywljy@gmail.com