Screen printing emulsion scoop coater

1.Feature of emulsion cooater

Double sided coating edge for either a sharp edge thin coat for higher screen mesh, or a rounded dull edge for coating lower mesh screens. Extruded from T6 aluminum this coater is easy to hold, sits easily on flat surface between coats, and holds a good amount of emulsion for lengthy coating sessions. 
The scoop coater comes complete with snapped and glued injection molded end caps, as well as a full top snap on dust cover. 

a. Easy and comforatable handing

b. Double-mouth coater,with caps pasted on two end,easy to clean and no leaking

c. Hold a good amount of emulsion for lengthy coating sessions.

d. Pre-cut into any size you need :14inch ,16inch ,18inch 20inch etc. Max length 80inch 200cm.

2.Size selection of emulsion coater

The most screens are measured to the outside diameter and there is about 4 inches of screen frame that doesn't need to be coated. For example: A 20x24 inch screen will only require a 16 inch scoop coater.

14 Inch - use for 18" x 20" screens.

16 Inch - use for 20" x 24" screens.

18 Inch - use for 23" x 31" screens.

20 Inch - use for 25" x 36" screens.

Welcome to contact us for more details.

Hebei hanze group