MKS MINI Controller board

Features:
 
MKS MINI is a feature all-in-one electronics solution for Reprap and other CNC devices.It features an onboard ATmega2560.
MKS-MINI is suitable for One-Extruder and no bed printing.
It's four motor outputs are powered by DRV8825 stepper drivers.
The board can use the same firmware as Ramps1.4.
The mounting hole locations is the same as Arduinos Mega2560.
The power supply with 7805, more stable and reliable than the 1117,but only supports 12V.USB to serial modules is 16U2, the same as Arduinos Mega2560.Without hot bed heating output,but has bed thermal interface and bed control signal interface.
 
Specifications:
 
Arduino MEGA compatible Atmega2560 processors are compatible with all RAMPS class firmware
Easy DISPLAY + SD-CARD connector,RepRap Discount
Smart Controller compatible pin header on board
Firmware can use the same configuration as ramps1.4
2x temperature ADC connectors for thermistors
up to 4 motor driver with DRV8825
2x PWM capable power mosfet outputs with voltage selector for MainPower.(Extruder0,Fans)
6x end stop connectors with power supply Xmin/Xmax/Ymin/Ymax/Zmin/Zmax
4 layers PCB,optimize heat dissipation.
Recoverable fuse for short-circuit protection.    

Further information, please feel free to contact us at sales@lankeda.com  
Or visit our website: www.3dprint.en.alibaba.com  and www.lankeda.com