Principle:

With drop force of bottom impact and side vibration, the manufacturer tightly fill the senior moisture-absorption chemical raw materials-molecular (Alumina) inside both drying towers. When the Moisture-Contained gas impacts the sorbent in a curve following specific flow direction, the vapor water in the air will be absorbed under the pressure state. The water will be released automatically from the sorbent with the instant pressure drop method when the sorbent absorbs the water and saturated. Just by this characteristic, this product works alternatively in the sequence of absorbing, releasing, regenerating and charging in the manner of shifting between two towers.

Features

1. The excellent design of the two tower or use our patent there towers desigh high efficiency

 It can ensure activated aluminium oxide contact time enough to dry the saturated wet air entering in dryer to the needed dew point, 30% extra desiccative can compensate the desiccative consumption and ensure the life time, then guarantee the best performance

2. Adopts the large scale diffuser

    To ensure the air stream well proportioned to get through the desiccative level

3. Reliable controlling system

  3.1 Within 10 minutes period dry the compressed air to very low dew point of -40°C or within 4 minutes period dry  to -70°C,and can be conditioned at site

   3.2 Micro CPU control way , and the PLC control is optional

4. System Pressure drop is lower than 0.02MPa

5. Easily operation & easily maintenance

     Power on-off switch, the period mode setting, power on light, regenerative on light

Technical parameters

Rated Inlet Temperature: ≤38°C

Maximum inlet temperature: ≤70°C

inlet oil content: ≤0.1ppm

Outlet Pressure Dew Point: -20°C (-70 °C below zero is optional)    

Adsorbent: Activated alumina or molecular sieve      

 Rated Working Pressure:0.5~1.0MPa(1.0MPa or above is optional)

Control Model: CPU (standard configuration), PLC is optional    

Power Supply: 220V/50HZ/60hz,380v/50hz-60hz

Working Mode: Automatic switching between tower A and tower B, continuous working 

Regeneration Way: Heatless regenerative

Regeneration Air Consumption: 3-8%

Cycle Period: 10~90min, adjustable

Power Supply: 220V/50HZ/60hz,380v/50hz-60hz