Reinforcing Mesh Welding Machine
Automatic Reinforcing Mesh Welding Machine
The mechanical reinforcing mesh production line is mainly used for producing construction reinforcing meshes.
Feeding mode: warps and wefts required by the equipment are pre-sheared by an automatic straightening cutting machine, the warps are placed on a corresponding wire penetrating mold by workers, and the wefts are placed into a special accommodation groove and are controlled for automatic blanking through a servo motor.
Welding: The main machine starts welding: the machine adopts a synchronous control technology, both branch control welding time and welding time are controlled by a PLC digital programming system, and the pore size can be adjusted only by direct input on a
touch screen control panel; a welding process is finished on the basis of spring pressurization.
Welding finish: The servo motor controls an automatic mesh drawing process until the whole mesh is welded, and the automatic
mesh connecting and discharging system is started; the welding of the next mesh is started.
Technical parameters
Wire diameter |
6mm-12mm |
Warp feeding |
Pre-shearing |
Weft distance |
Min 50mm |
Weft feeding |
Pre-shearing |
Warp distance |
100mm-300mm |
Power supply |
AC380V-440V |
Warp quantity |
26 |
Welding width |
2500mm |
Mesh length |
6m |
Welding speed |
45 times∕min |
Dimensions |
10*3.4*1.6(m) |
|
|
Reinforcing Mesh Welding Machine
Automatic Reinforcing Mesh Welding Machine
The mechanical reinforcing mesh production line is mainly used for producing construction reinforcing meshes.
Feeding mode: warps and wefts required by the equipment are pre-sheared by an automatic straightening cutting machine, the warps are placed on a corresponding wire penetrating mold by workers, and the wefts are placed into a special accommodation groove and are controlled for automatic blanking through a servo motor.
Welding: The main machine starts welding: the machine adopts a synchronous control technology, both branch control welding time and welding time are controlled by a PLC digital programming system, and the pore size can be adjusted only by direct input on a
touch screen control panel; a welding process is finished on the basis of spring pressurization.
Welding finish: The servo motor controls an automatic mesh drawing process until the whole mesh is welded, and the automatic
mesh connecting and discharging system is started; the welding of the next mesh is started.
Technical parameters
Wire diameter |
6mm-12mm |
Warp feeding |
Pre-shearing |
Weft distance |
Min 50mm |
Weft feeding |
Pre-shearing |
Warp distance |
100mm-300mm |
Power supply |
AC380V-440V |
Warp quantity |
26 |
Welding width |
2500mm |
Mesh length |
6m |
Welding speed |
45 times∕min |
Dimensions |
10*3.4*1.6(m) |
|
|