SF600 SPI Flash IC Programmer

The SF600 is a high speed In System Programming (or ISP) programmer designed to update the SPI Flash soldered on board (In Circuit Programming) or in the separately available socket adaptors (Off line programming).
Contact us if you need a socket adapter for your chip.
The programmer is easily controlled by the DediProg Software through the USB bus offering friendly interface and powerful features to users.

Powered by USB - additional power supply is available for stand alone programming.

The SF600 combines the advantages of SF100 with additional improvements: High speed USB and higher SPI performances.

Features :
• USB High speed and high SPI performance, support up to 2Gb SPI Flash
• In circuit Programming: Program on board SPI Flash
• Off line Programming: Program SPI Flash in the socket (available separately)
• Program two Serial Flash memories
• Start button feature: Able to Batch in the USB mode
• Signal conflict protections
• Multi-Programmers Capability through USB
• Support 1.8V low voltage IC
• Support Windows 2003 and above - including Win7, Win8 and Win10
• Support both 32 and 64 bit OS
• Support 1 CS pin

SF600 is designed with ISP header, through an appropriate connector, users can connect the programmer and drive the SPI signals, supply the memory and control the controller or application status.
Please refer to the user manual for the SF600 2x10 header pin out.
DediProg also provides the SF600 ISP Cable which is used to connect the SF600 programmer to the 2X6 2.54mm ISP Pin Header on board, please refer to the user manual for the SF600 ISP Cable 2x6 pin out.

The SF600 USB software tool chain offers high flexibility and fit the different and highest requirements:

Engineering Graphic User Interface:
For engineers and expert to access advanced features for development, repairing etc.

Production Graphic User Interface:
For operators in production to control multiple programmers and improve the throughput.

Command line interface:

Customer software can control the multi SF600 programmers (SF600 integration, Control SF600 with Production In Circuit Tester.)

Contents : 
• 1 x SF600 Programmer
• 1 x USB Cable
• 1 x ISP Cable (ISP-600-CB1-G)
• 1 x SF100 2.54mm 2*4 ISP Cable (ISP1-CB)
• 1 x SF600 Universal Adaptor (ADP-SF600-TO-SF100)
• 1 x CD-ROM (Included Software, specifications and user manual)

SF600 Universal Adaptor (ADP-SF600-TO-SF100)
The SF600 Universal adaptor is used to convert SF600 2X10 2.54mm header pinout to SF100 2X7 2.54mm header pinout. User can Use this universal adaptor when the ISP header pinout on application board is designed according to the pinout of SF100 ISP cable.

SF100 2.54mm 2*4 ISP Cable (ISP1-CB)
The SF100 ISP cable is used to connect the ISP SF100 programmer to the 2X4 2.54mm ISP Pin Header on board offering the possibility to update directly the SPI Flash content. In case of frequent connections, the ISP cable must been time to time changed to ensure a good contact with the application board signals. The ISP programming method should only been used if supported by your application or controller.

ISP Cable (ISP-600-CB1-G)
The SF600 ISP cable is used to connect the ISP SF600 programmer to the 2X6 2.54mm ISP Pin Header on board offering the possibility to update directly the SPI Flash content. In case of frequent connections, the ISP cable must be time to time changed to ensure a good contact with the application board signals.
The ISP programming method should only be used if supported by your application or controller.