Surise Photosensitive adhesives photobond 300K

Model:	PHOTOBOND 300K
Brand:	Surise MSI
Origin:	Made In Japan
Category:	Chemicals / Adhesives & Sealants
Label:	Surise MSI , photobond 300K , photobond
Price:	-
Min. Order:	-

Inquire Now

Product Description

Ultraviolet cure adhesives PHOTOBOND

PHOTOBOND is adhesive that cures with exposure to ultraviolet light. We were the first to put it to the practical use.
PHOTOBOND is widely used to adhere glass and resins that pass ultraviolet light.
We are the leading brand of Japan and popular among many customers.
The application of the PHOTOBOND is now extended from glass crafts to optical lenses and electronic components, and we are currently developing products for special uses, coating and temporary joint as well.

Product Line-Up

■ PHOTOBOND 300	For art glass	■ PHOTOBOND 300K	For optical applications / standard product
■ PHOTOBOND 029	For adhesion of different materials / Low viscosity	■ PHOTOBOND 150	For optical applications / low viscosity
■ PHOTOBOND 200	For coating and sealing purposes / aerobic	■ PHOTOBOND 470 ■ PHOTOBOND 475	For optical applications / Light resistance and heat resistance
■ PHOTOBOND 840	Low Viscosity / warm water detachable

Used in such places

Usage Information

General instruction (*Please conduct adequate pretest according to your purpose.)

1. Remove dust, oil and dirt

First, clean the work surfaces removing dust, oil and dirt by using solvent, etc.
If you use solvent, wait until the solvent thoroughly evaporated before you started adhering work.

2. Apply PHOTOBOND and adhere

Apply PHOTOBOND to the surface to be adhered, and press the other work surface firmly onto it.
If bubbles appear this time, they would weaken the adhesive power.
In that case, rub the work surfaces each other to eliminate the bubbles.
The most suitable thickness depends on the adhering conditions. Conduct adequate pretest.

3. Fix work pieces and irradiate ultraviolet light

Use a fixing device to prevent the work pieces from moving.
From the direction more ultraviolet passable, irradiate ultraviolet light vertically and evenly against the work surface. The irradiation time differs depending on adhering conditions. Please conduct adequate pretest.
When the adhering surface is large, move the irradiation position gradually, and ensure the entire surface gets the irradiation evenly.

4. Wipe away the runoff PHOTOBOND

The runoff PHOTOBOND does not cure when exposed to ultraviolet as far as there is oxygen.
After the irradiation, wipe it away by suitable solvent (alcohols solvent, petroleum benzine, carbon-hydride cleaner).

For the purposes such as coating that cannot block the air, refer to the following information:
1) Place entire work pieces in vacuum.
2) Conduct irradiation in work condition filled with inactive gas such as N2 (nitrogen), CO2 (dry ice).
3) Cover the surface by transparent polyethylene film, etc., and irradiate ultraviolet light through it. Remove the film after the irradiation.