ER80 QR Code Access Card Reader can work with all Door access control board with built in WG 26/34output.The user can open the door by RFID card or Mobile QR code.

        

Card Reader Technical Parameter

Size（L*W*H）	86*86*42mm
Material	Case：PC identify panel：tempered glass
Interface	Wiegand26、34 、RS485、RS232、USB、TCP/IP optional
Decoding support	QR、one dimensional code
Voltage	Support 4-15V input
Current	800mA
Reading directions	Camera centric slant 45°
Reading speed	<200ms
Reading range	0-20CM
Reading feature	auto-induction, beep hint
Light source	With LED light source itself，anti-highlight interference
Decode Mode	Image decoding
environment	Temperature：-20~70℃ Humidity：10%~90%
Operate system	Windows(xp 7 8 10)、Linux
Indicating status light	Red-Work、Green-Feedback、Light Green-Internet
Reading range	3-6CM
Reading card type	EM or Mifare card

Restore  Factory Settings: Use sharp objects inserted into backside REST hole，release till reader automatically restarted.

 

Features:

1. DC 12V 1000MA

 

2. EM card or Mifare Card for choose

 

3. Identify printed or screen QR Code

 

4. Support 26/34 weigand output to third party Access Control system

5. RS232, RS485, USB virtual keyboard, USB virtual Serial port, HTTP output, MQTT output optional

 

Wire connection:

VCC：DC12；    GND：DC12；D0:DATA0；D1:DATA1； LED:LED indicate； BEEP:Sound ；

 

TX/R+:RS232+/RS485+；

RX/R-:RS232-/RS485-；

SPK-、SPK+：not define；

 

RJ45：connect to network, PC software setting reader parameter；apply to HTTP mode

micro-USB：For USB virtual keyboard and USB virtual serial port mode communication.

 

Note:

1: do not connect the power to the SPK+ and SPK- ports;

2:Wiegand output, QR code shall comply with the principle of combination of 16 hexadecimal number 0~F, the QR code in accordance with this principle can heard a Beep, controller can receive the card data; QR code not in accordance with the principle can heard two beep, the controller can not receive the card data;

3: Wigand output, scanning QR code take number principle is high before, QR code automatically identified as 16 decimal;

4: WG34 output, QR code card number must be 4 bytes, insufficient in high fill 4 byte number with 0.