ESCRIPTION
Self adhesive bitumen flashing tape is a self-adhesive, aluminum or high density 
polyethylene surfaced bitumen & SBS rubber backed sealing strip. It is a quick, efficient 
and cost effective method of flashing, sealing and repair that produces a lasting protection 
in all climates.
 CHARACTERISTIC
Self-adhesive without bonding agent, torching 
Good self-coalescence
Safe application, no pollution
Corrosion resistance and ageing-resistance
Provides an instant seal
Easily applied by hand pressure only 
Available in wide range of widths, thickness, colors
 TYPICAL USES
GENERAL:
Vehicle maintenance and repair, sealing around pipes and tanks, repairs to weatherproof
enclosures, sealing over wood, concrete brick most metals and some plastics.
CONSTRUCTION:
*Replacement or repair of flashing

* Gutterring, down pipes. Skylights

*Extensions, porches. Window frames & chimneys

*Caravans & Conservatories

*Sealing parapets, Valley gutters

*Seals capping bolts & roof ridges

*Roof repair of portable buildings

 PACKING 
Thickness: 1.0MM, 1.2MM, 1.5MM
Width: Available in 50 mm,75 mm,100 mm,150 mm,200 mm,225 mm,250 mm,300 mm 
450mm etc
Length: 2.5 m,3.0 m, 5.0 m,1 0m,20 m 
Special sizes made to order
 STORAGE
Store under cover, out of direct sunlight and protect from extreme temperature. In tropical 
climates the product must be stored in an air-condition environment. Shelf life is up to 12 
months when stored as per recommended storage condition. 
 HEALTH & SAFETY
As with all bitumen products caution should always be exercised. Protective clothing such 
as gloves and goggles should be worn. Treat any splashes to the skin or eyes with fresh 
water immediately. Should any of the product be accidentally swallowed, do not induce 
vomiting, but call for medical assistance immediately.
 APPLICATION
1 Make sure the surface smooth, clean, no dust or other loose material
2 Cut the flash band t to required length 
3 Remove the release paper. Press flash band into place, using fingertip pressure. Avoid 
excessive pressure
4 When laying adjacent rolls the flash band must overlap by at least 25mm
5 Use a seam roller or rounded piece of wood to smooth the flash band and ensure good 
contact is made
 Overpainting:
Flash band can be overpainted with conventional decorative paints, though a little staining 
may occur at the edges.
 Note:
In cold weather, application will be made easier by warming the surface and by storing 
flashing band in a warm place prior to use. Do not apply if surface temperature is below 5℃