Corrosion Test for Engine Coolants Tester       ASTM D1384
Product model: JF0085

Introduction 
The main principle of the Corrosion Test for Engine Coolants Tester is to process six typical metals used in the engine cooling system into test pieces, connect them to form a test piece bundle after weighing, and then completely immerse in the specified sample. At the end of the test, the test piece was taken out and weighed again after being cleaned, and the corrosion was evaluated based on the corrected mass change value of the test piece before and after the test.
The Corrosion Test for Engine Coolants Tester is suitable for high boiling point and terrestrial engine coolant and its concentrated liquid. The Corrosion Test for Engine Coolants Tester is also suitable for engine cooling system rust inhibitors.

Technical Parameter
1.Applicable Standard: ASTM D1384 
2.Heating Method: Electric heating tube heating
3. Temperature Control Method: Digital display PID temperature controller
4. Working Unit: 3 holes
5. Timing Method: Digital display timer
6. Cooling Method: Low temperature circulating water
7. Pressure Control: Dense regulator valve
8. Refrigeration Method: Compressor refrigeration
9. Flow Rate Control: Dense flowmeter
10. Power Of The Whole Machine: 2.5KW
11. Power Supply: AC220V/50HZ
Performance characteristics
1. Fully enclosed compressor refrigeration to ensure the supply of cold capacity;
2. Stainless steel cold bath with holes for adding medium on it;
3. The glass test tube meets the standard requirements;
4. Dense regulator valve controls the air intake source, and the flow meter adjusts the flow rate: 100ml/min±10ml/min;
5. Microcomputer temperature controller, digital display, ±0.1℃ PT100 sensor;
6. Digital timer, recording experiment time, with phoenix buzzer;
7. Sand core glass gas diffusion head;
8. 6 sets of metal test pieces, which meet the requirements of ASTM standards;
other