Brief description:

Parallel autoclave units are suitable for parallel catalytic reactions, parallel high-temperature and high-pressure synthesis screening, kinetic testing, Fischer-Tropsch reactions, hydrogenation reactions, polymerisation reactions, homogeneous reactions, etc.

The function description and technical parameters of the parallel autoclave unit are as follows:

◆Using inserted K-type needle sensor,316L stainless steel. Maximum working temperature: 350°C. Temperature display accuracy: ±1℃. Design pressure: 25MPa, working pressure≦22Mpa. standard configuration: reaction kettle body made of 316L, electric fiber furnace, needle valve and ball valve and pressure gauge, 1.5m stainless steel connecting pipe, one set of spanner.

◆Stirring speed and temperature are digital display 0-1500RPM, speed accuracy ±5RPM, power supply: 220V, 50HZ, stirring power: 25W-120W with model, heating power: 300W-1200W with model. Insulation layer: vacuum shaped environmental protection insulation body made of aluminium silicate cotton, insulation layer: alkali-free glass fibre, insulation coefficient: ≥500 megs at relative humidity ≤35%. Working time: single continuous working 72 hours.

◆ Equipped with 25Mpa pressure gauge, and intelligent pressure relief valve. The highest pressure is less than 22Mpa, and the pressure accuracy is 1Bar.

◆The valve fittings are American standard, and the interfaces are all standard configuration. The ball valve can be connected to an inert gas filled bottle for inert protection of the experimental reaction, so that the reactants are not in direct contact with air.

The parallel autoclave device simplifies the tedious experiments and can be used to carry out diverse series experiments in different environments or at different temperatures/pressures in the same environment on the same operating table, and can be connected to a computer via RS232 communication interface to print and display the historical values and actual curves required by the user, and monitor the whole system in real time through software. (Optional)