Self-adhesive flashing tape

 

Description

The tape is a self-adhesive, rubber modified, bituminous sealing tape for the

sealing of cracks and joints in many common domestic and commercial situations.

It consists of an aluminum foil reinforced by a polyester film and coated with a cold adhesive bituminous compound.

 

Uses

The TAPE is used to seal cracks and joints on:

• Roofs              - around chimneys and skylights.

                        - over joints/cracks in tiles and roof cladding.

• Exterior walls      - joints and cracks in asbestos cement sheeting.

                        - cracks under masonry ties and anchorages.

                        - around wall penetrations (such as water pipes).

                        - gutters and downpipes.

• Terraces           - at joints between terraces and exterior walls.

                        - joints in parapets.

                        - roof edges, sides, flashings and joints.

• Inside the house  - leaking pipes, showers, etc.

 

Advantages ·

•    Very easy to apply
• · Very economical
• · Good adhesion to many substrates
• · Weather-proof
• · Self-adhesive
• · UV-resistant
• · Bitumen-resistant
• · Can be over-painted
• · Can be applied at low temperatures

 

Product Data

Appearance

- Upper side: laminated aluminum foil 

- Lower side: Self-adhesive black bituminous tape protected with a release film

 

Packaging:

Available in 50 mm,75 mm,100 mm,150 mm,200 mm,225 mm,250 mm,300 mm rolls of

1 0m,20 m length

 

Special sizes made to order

 

Storage & Shelf Life:

72 months from date of production if stored in unopened, undamaged original sealed

containers, in dry conditions and protected form direct sunlight at temperatures

between +5°C and +25°C.

 

Technical Data

Chemical Base Rubber modified bituminous tape

Density 1.2 - 1.5 g/cm³ (+20°C)

Layer Thickness ~1.2 mm (incl. aluminum foil of ~ 0.05 mm)

Fire Rating B2 according to DIN 4102

Service Temperature -20°C to +70°C

 

Mechanical / Physical Properties

Tensile Strength   Longitudinally: approx. 3.6 N/mm²

                      Transversally: approx. 3.5 N/mm²

Elongation at Break 25 – 50%

 

Application Details

Substrate Quality The substrate must be sound, clean, dry and free from all surface contaminants.

Substrate Preparation · All loose particles, release agents, laitance, paint, rust and other poorly adhering materials must be removed by suitable hand or mechanical preparation

techniques.

Metallic substrates, plastics, etc. have to be thoroughly cleaned with a solvent

On porous substrates (concrete, renderings, etc.) the adhesion can be improved

with a bituminous primer (e.g. HY Primer). Do not apply HYA-TAPE until the HY Primer has dried.

 

Application Conditions / Limitations

 

Substrate Temperature +5°C min. / +40°C max. At temperatures below +10°C the tape and the substrate must be warmed up before and during the application. Use hot air equipment.

 

Application Instructions

Application Method / Cut the tape to the necessary length, remove the release film and press the tape

Tools firmly onto the substrate with a suitable pressure roller. Where lengths of HYA-TAPE

must be joined, ensure the joints are overlapped by a minimum of 50mm.

Note: Adhesion to the substrate can be increased by heating up the tape with a hotair-dryer during the application.