Allow the test, specimen, extraction buffer to equilibrate to room temperature (15-30°C) prior to testing.

1. Remove the test device from the sealed foil pouch and use it as soon as possible. Place the test device on a clean and level surface. Best results will be obtained if the assay is performed immediately after opening the foil pouch.

2. Unscrew the whole cap of the specimen collection tube,

3. Take out the bottle of Sample Extraction Buffer, remove the bottle cap, add all the extraction buffer into the extraction tube.

4. Place the sterilized swab specimen in the sample extraction buffer. Rotate the swab for approximately 10 seconds while pressing the head against the inside of the tube to release the antigen in the swab.

5. Remove the sterilized swab while squeezing the sterilized swab head against the inside of Buffer as you remove it to expel as much liquid as possible from the swab. Discard the sterilized swab in accordance with your biohazard waste disposal protocol.

6. Screw on and tighten the cap onto the specimen collection tube, then shake the specimencollection tube vigorously to mix the specimen and the sample extraction buffer. See illustration 4.

7. Add 3 drops of the solution (approx.80ul) to the sample well and then start the timer. Read the result at 10~20 minutes. Don’t interpret the result after 20 minutes

Date sheet