Model: PS-1500

1500 Watt Pure Sine power Inverter with built-in battery charger and transfer switch. This inverter charger is perfect for small-sized industrial applications that depend upon power being available even under heavy load. This heavy-duty inverter charger is ready to go wherever you need it. Use this product for renewable solar, off-grid home and business back up power, mobile and emergency backup power applications anywhere that uses 110 or 120 volts of alternating current.

This inverter is also great in a smaller RV or boat. If 1500 watts is not enough power, check out our full line of low frequency inverter chargers available in 12, 24 & 48 volt versions. This  power inverter charger is capable of accepting any source of 120v AC power to charge batteries, including a gas or diesel generator or shore power at an RV park/truck stop. It will even accept power from an extension cord pl ed into your wall outlet at home.

The most sought-after capability this unit has is its direct connect terminal block, which allows a 300 percent surge capacity. When using the terminal block, this inverter peaks at 4500 watts with the power to run most-all tools and appliances with high startup surges. This inverter will never completely drain your batteries as it's low-voltage shut-down keeps the voltage at either 20 volts or 21 volts depending on your selection. With the battery priority mode, you can set your inverter to run directly off of a battery back-up system instead of a generator or tertiary source of AC Power. The inverter charger comes with a power saver mode that pulses every 30 seconds, attempting to detect a necessary load of 25 watts or more before it will turn on. Otherwise, the inverter will “sleep” and draw right around a half an amp per hour, saving you precious reserve power in your batteries until you need it.

An optional wired remote can be added for fast and easy operation if your inverter charger is mounted in a location that is inconvenient to get at. This allows the unit to be operated within the cab of a vehicle or from another location in the home or campsite.

Optional Features:  
* Remote on/off switch with LCD display screen for  
aims pure sine inverter chargers - The LCD display  
screen monitors battery voltage, AC input voltage, AC  
output voltage, output frequency and output load  
percentage etc. The remote can be flush mounted into  
a dash, job box or anywhere for quick access to key  
information.  
* Auto generator start - The inverter can be customized  
to start-up a generator when the battery voltage goes  
low.    

Battery Charger:  
* The 1500Watt 24VDC  
Pure Sine Inverter Charger  
Max 4600W is equipped with a  
powerful 4-step smart charger  
capable of charging at 25Amps  
* The built in battery selector for  
this inverter works with Gel USA.  
AGM 1, AGM 2, Sealed Lead  
Acid, Gel EURO, and Open Lead  
Acid battery types etc.

Specifications for PS-1500

Inverter Output Specifications:

Continuous Output Power: 1500 Watts

Surge Rating: 4500 Watts 

Output Waveform: Pure Sine/Same as input (Bypass Mode)

Output voltage: 120VAC±5%

Power factor:   0.1~1

Nominal Efficiency: >88% (Peak)

Line Mode Efficiency: >95%

Output Frequency: 50Hz +/- 0.5Hz / 60Hz +/- 0.5Hz

Typical Transfer Time: 8ms (Max)

Bypass Breaker - 20 amps

THD: < 5% 

Ambient operating temperature: -4°F to 122°F (-20°C to 50°C)

 

Input Specifications:

Nominal Input Voltage: 24.0Vdc

DC Input voltage range: 20.0~32.0v

Minimum Start Voltage: 20.0Vdc

Low Battery Alarm: 21.0Vdc +/- 0.6VDC

Low Battery shutoff: 20.0Vdc +/- 0.6VDC

Low battery Trip: 20.0Vdc-21.0Vdc

High Voltage Alarm: 31.0Vdc

High Voltage shutoff: 32.0Vdc +/- 0.6VDC

Idle Consumption: 26.5 watts

Power Saver Mode Idle Consumption: 10.0 watts

 

Charger Specifications:

Output voltage: Depends on battery Type

Charger Rate:25A

Over Charge Protection Shutdown 31.4V

Selectable Charge setting based on battery type

Adjustable charge current off--40%/60%/80%/100%

Four Stage Smart Charger

 

Transfer Switch Specifications:

30 amp auotmatic transfer switch

8 ms (max)

Dimensions:

Unit Weight: 42 lbs.(19kgs)

Unit Size L x W x H: 18.83 x 8.67 x 7.10 inches (48x22x18cm)

Shipping Weight: 53 lbs.(24kgs)

Shipping L x W x H :23..62 x 13.39 x 12.99 inches (60*34*33cm)