ZXQ-2B type automatic metallographic specimen setting machine automatic type pneumatic mechanical setting machine, through the force exerted by the cylinder to make the steel mold in the steel mold set up and down, thermosetting plastic with the inlaid specimen in the heating conditions. The molding pressure during sample preparation is automatically compensated by the spring fixed in the body of the machine, and the pressure of sample pressing can be indicated by the signal lamp. This machine is equipped with intelligent digital display thermostat, set time, set temperature are displayed, the temperature sensor using thermocouples. This machine has the advantages of high sensitivity, high precision, temperature display, easy to observe and easy to operate.

The working environment：

1. altitude of not more than 1000 meters;

2. the surrounding medium temperature is not higher than +40 ℃, and not lower than -10 ℃. 3, the air in the relative humidity of not more than -10 ℃;

3. air in the relative humidity is not more than 85% (at 20 ℃);

4. there is no conductive dust, explosive gases, and corrosive gases that can seriously damage the metal and insulation;

5. No significant vibration and bumps

Technical parameters：

Model : ZXQ-2(Φ25)

Specimen pressing specification：Φ25mm

Heater specification：800W

Temperature adjustment range：0-300℃

Timing control：0-99 minutes

Main body net size：330*255*475mm

Power supply：220V

Weight：32kg