Digital Wire Processor

From AWG 12 to AWG 30,

the KM-702N cuts and strips various types of wires,

With the Five-Line blades and a pair of discharge rollers,

the KM-702N will bring you a sucessful result.

Various sensors and operator friendly set-up with graphics are standard.

In addition, special blades for flat cable can be installed as an optional choice.

‣ Features

- Graphic display for easy set-up

- Push button set-up of all machine functions

- Auto knife sensoring for stripping blades set-up

- Up to 100 recipes for saving of standard set-ups

- Count of pieces needed

- Short mode for wires less than 35mm long

- Single-step cycle

- Cut botton for testing cutting of machine

- Emergency stop button on panel

- Wire run-out and/or tangle detectors

- An air pipe for insulation chip removal during the cycle

- Filter & regulator for pneumatic system   ‣ Auto Strip Sensor

  Auto knife sensoring for stripping blade set-up.

‣ Roller Up&Down Button   With a simple-button press, discharge rollers can be open and close.
    ‣ Feeding Part

 - Six rollers for highly accurate feeding and stripping.

- Discharge rollers open during feed to protect leading wire end.
    ‣ Cutting Part

- Five line knife system allows the running of five wires at once for high production

- Blade life time is estended maxium five times compare to competitor’s model

- An air pipe removes insulation chip during operation

* Specifications are subject to change without notice.