SPECIFICATION：

Coin diameter               : 20mm～28mm

Coin thickness               : 1.2mm～2.5mm

Voltage                         : DC12V±20%

Temperature                  : -15℃～+75℃

cpu protection system for anti-string and monitor for coin speed control

10 seconds alarm and auto-stop(coin reject)

Anti-False Coin

Anti-String Trick

Anti-Sparking

Anti-High Frequescy

Auto-lockout while coins moving reverse

Auto-lockout while coins blocked

Anti-sparking and magnetic influence

Verify coins by digital signal effect

INSTALLATION:

1. Remove the factory plastic token from the coin sampling clamp and install the right coin used.
2. Slide the coin clamp backward & insert a right coin into the clamp slot then pinch the coin.
3. Adjust the insert slot opening size by loosening the screw in the back side of front panel to fit your coin’s diameter if necessary that can prevent the bigger invalid coins from inserting.
4. Select the right mode between Normal Open & Normal Close.

Choose the right speed of coin acceptance among 100ms (Slow speed/Long pulse) & 50ms (Medium speed/Medium pulse) & 30ms (Fast speed/Short pulse) by TIMER SWITCH for synchronizing with your software.

1. VR turning for sensitivity of coin acceptance turn clock wise(-) for slack coin selection &anti-clock-wise(+) for strict coin selection against slugs.
2. lines guide of 5 lines with 4 pins connector:

Gray line   ------ Counter(+/-)------------------

Red line    ------ DC+12V              ↓

White line  ------ Coin signal          8|8|8|8|8|8

Black line  ------ GND (Ground)          ↑Counter

Gray line   ----- Counter (-/+) ------------------