BB three-dimensional electronic fireplace (Jardine's Lookout, Hong Kong) Precautions

1. Reserve a power socket, but it cannot be placed at the bottom. The specifications are three-hole 250V 10A and the flame function is 210W.

2. There is a water tank in the fireplace for atomization, with a capacity of about 1.5 liters, depending on the size of the fireplace.

3. The BB three-dimensional electronic fireplace needs to reserve air inlet space to ensure that it can produce the best and lifelike flame, otherwise the flame will be very weak or cannot be produced.

4. Pure water needs to be injected into the three-dimensional electronic fireplace. Do not move it after injection, otherwise the water will overflow, short-circuit and damage the stove. Do not add too much water each time.

5. After installation, adjust the left and right circular flame size knobs, counterclockwise for small, clockwise for large, and complete after controlling the flame.

3D electric fireplace installation instructions

1. First place the fireplace flat in the location where it needs to be installed;

2. Remove the firewood or stone; remove the top water inlet cap counterclockwise;

3. Fill the water tank with pure water without overflowing. Fill the water tank with about 1.5L of water and tighten the cap;

4. Do not move the stove after filling it with water.

5. Turn on the power switch

6. Place the wood;

7. Adjust the left and right circular flame size knobs;

8. After about three minutes, the flame port will automatically burn out a lifelike flame;

9. Fill it with water once and it can produce flame continuously for about 10 hours;

10. Do not use tap water or sewage, otherwise, the fireplace will be damaged quickly!

It is recommended to take a break for about half an hour after every ten hours of use.

Contact person; Peter Ma

Email: peter@bbfires.com

Hong Kong contact number: 852-67625988,

WeChat: 13714791523