| Input |
Voltage range |
90~264Vac, 135~370Vdc |
| Frequency range |
40~63Hz |
| AC current |
0.9A/100Vac |
| Inrush current (max.) |
30A/230Vac |
| Leakage current(max.) |
0.25mA/240Vac |
| Protection |
Over load |
>110% rate output voltage power for 5.0V~36V |
| Protection type:hiccup mode,recovers automatically after fault condition is removed |
| Short circuit |
Power shutdown |
| Auto recovery after fault condition is removed |
| Environment |
Working Temp. |
0~40℃ |
| Working Humidity |
20%~90% RH non-condensing |
| Storage Temp. Humidity |
-20℃~85℃, 10%~95% RH |
| Temp. Coefficient |
±0.03%/℃ (0~50℃) |
| Vibration |
10~500Hz, 2G 10min/ cycle,period for 60 min,each along X,Y,Z axes |
| Safety & EMC |
Safety Standard |
UL60950, EN60950,EN61558 |
| Withstand voltage |
I/P-O/P:3KVac, 1 minute |
| Isolation resistance |
I/P-O/P: 100M ohms/500Vdc/25℃/70%RH |
| EMI condition & radiation |
Compliance to EN55022 class B, FCC part15 class B |
| Harmonic current |
Compliance to EN6100-3-2,3 |
| Others |
MTBF |
100Khrs min, MIL-HDBK-217F(25℃) |
| Dimension |
105mm*45mm*27.8mm |
| Packing |
120pcs/Carton |
| Connector |
Plug |
According to client's requirement |
| Cable |
18# or 20#, other type available by client's requested |
| Note |
1.Al l parameters are specified at 230Vac input, rated load,25℃ 70% RH ambient; |
| 2.DC voltage: the output voltage set at point measure by plug terminal & 100% load; |
| 3.Ripple & Niose are measured at 20Mhz bandwidth by using a 30cm twisted-pair wire terminated with a 0.1uf & 47uf parallel capacitor |
| 4.Tolerance: includes set up tolerance, line regulation, load regulation, |
| 5.Line regulation is measured from low line to high line at rated load, |
| 6.Load regulation is measured from 0%~100% at rated load |
| 7.Efficency is measured at 100Vac, |
| 8.The power supply is considered a component which will be installed into a final equipment.The final equipment must be |
| re-confirmed that is still meets EMC derectives |
