YG-D1450 Solar Powered Lights Instruction

1. Introduction

YG-D1450 solar powered light consists of a solar panel and rechargeable light. As long as the solar panels placed in sunny outdoor, lights will be illuminated at night, therefore, this solar powered light is most suitable for families in areas where there is no electricity or where there are frequent power failures. Lights can be hung on the indoor walls, or mobile hand-held, easy to use.

2. Technical parameters
(1). solar panel: the output voltage> 6.5V, maximum output current 380mA.
(2). light: 51pcs white LED, rated power 3W; built-in battery 4000 mAH.

3. User Manual

(1). Charge up light:
* Solar panel must be placed outdoors, and adjusted to form an angel of 15 ~ 35 degrees with the ground to ensure the best absorption of sunlight.

* Lead the output electric wire of solar panel indoors, insert solar panel output plug into“input port of solar charging ”after confirming light switch placed "OFF" position, the“Charging indicator light” should be on to indicate that internal battery is being charged by the solar panel.(Note: If there is a mains power supply, which can also be used to charge the light, make sure the switch placed "OFF" position, and then take the charging electric wire plug of mains power supply out and insert this plug into the socket of mains power supply AC220V/50Hz. The “charging indicator light” will be on, indicating the mains power supply is charging the light.)

(2).Illumination:

With the illuminating switch to “Bright” position, the light will be glowing brighter, for a time of between 2.5~4.5 hours. In the “Normal” position, the light will not glow as bright but will last between 3~5 hours.

4. Notice

(1).If the lamp can not light up when the illuminating switche is turned to "Bright" or "Normal", the battery will need to be charged by the solar panel or mains power supply immediately.

(2).The light cannot be charged by the Solar panel and mains power supply AC220V/50Hz at the same time. When light is being charged by the solar panel or mains power supply AC220V/50Hz, the illuminating switch must turn to “OFF” position. To avoid any damage of internal circuits and accessories, DO NOT turn on light.

(3).If light is not used for a long time, the internal battery must be recharged every 3 months to be protected.

(4). DO NOT dismantle their own lights to avoid accidents such as electric shocks.

(5).Handle gently when using and moving, to avoid any damage to light and solar panel.

For more information, 
please contacts: Mr.Sunny Zhao
Tel: 0086 755 89982280 ext.8005
Mobile: 0086 755 89982834
Skype:sunnyzhao81