This anti-collisison device is a tower crane safety system. It has the following functions:

dynamic picture of positions among tower cranes;

pre-alarm and alarm in case of collision;

wireless upload parameters

 

CXT/800 system protection

Tower crane Anti-collision protection

    If tower cranes are with the same height, this system can control and handle it effectively, once detecting that  the  running  jibs  interfere  with  each  other automatically. While not with the same height, this system can also work effectively once acticipating the hook or cable of the higher tower crane may collide the jib or couter jib of lower one.

Zone(obstacle) anti-collision

Due to the complexity of some sites,the system can automatically  and  effectively  determine  up  to 10 prohibited zones in which the hook or jib are not allowed to operate.

Boundary protection

Complicated  environment  usually  exists  around work site.The CXT/800 system can be preset with a up to 30-point boundary protection area in which the operating or over-flying of hook is not allowed. It can  effectively prevent accielents from happening.

Pre-alarm/alarm and control

CXT/800 system allows the operator to work at maximum efficient way and optimize the use of

crane.  once  monitoring  the  pre-set  data  for possible collisions in  crane  interference area and over-flying of sensitise areas, there will be pre-alarm and visual and audible alarm and the system will stop the maneuver automatically to maintain a safety margin