|
SW-1160 release agents a kind of epoxy release agent. Compared with similar products with the stripping force is small, Fine and stable quality and so on. Applied to carbon fiber bicycles, rackets and other products from the type of production process
Main technical parameters
| Exterior |
Colorless or light yellow
|
|
N/100cm2 Stripping force N/100cm2
|
≤40 ≤ 40
|
|
Stripping product appearance
|
Fine, no skin
|
|
ppm Moisture ppm
|
≤300 ≤ 300
|
|
℃ For temperature ℃
|
70～150 70 ~ 150
|
Usage:1, first with the appropriate solvent or cleaning agent and thoroughly clean mold release agent to remove residual or previously Other pollution, and then a clean cloth or towel.
2, the use of air or air assisted spray equipment, used hair brush or cotton cloth wipe test.
3, in the pre-processing or clean the mold, spray 2-5 times a uniform SW-1160 to fully cover release agent Covered in mold.
, after each ejection, the whole mold Reapply that a layer of SW-1160, to ensure good off
Model effects. Wipe the hot mold release agent products (100 degrees), and then drying the mold.
Storage and Handling:
1, the SW-1160 stored at -5 ~ 35 º C, to ensure the best results.
2, when not in use keep containers sealed sealed to prevent contamination.
|
