Guangzhou Shenhuo straw stalk gasifier dedicated ignition rod (containing a-block with a light type)
Instructions
Guangzhou Shenhuo straw stalk gasifier dedicated ignition rods of stainless steel heating pipes, connecting rod, handle and power-line composition, first embedded-block LIGHT "0" type longer handle, with the ignition is simple, fast, health, safety and durability characteristics.
Features
1, the country's first embedded-block LIGHT handle a wide viewing angle can be bright to reflect the power state of the ignition rod.
2, heat pipe with high temperature resistant stainless steel tube production, a high degree of oxidation resistance and insulation, replacement easy.
3, handle new and unique look, using temperature materials, injection molding, and lengthened the design, the low temperature feel good.
4, the ignition rod in power about 30 seconds can make smoke Burden, 60 seconds to ignite furnace charge.
Specifications
Rated Voltage: 220V AC max power: 300W
Stainless Steel Rod length: 300mm Handle Length: 140mm
Heat pipe diameter: 10mm heat pipe wall thickness: 0.8mm
Ignition rod length: 440mm Power cord length: 2000mm

Use
1, first insert the furnace charge in the ignition stick, and then plug the power cord, when the handle front said that it has power indicator light.
2, power not to move as much as possible after the ignition sticks, lit furnace charge as soon as possible after the first unplug the power cord and then carefully pulled out the ignition rod.
3, pulled out after going to the flat end of the ignition rod move, flat-set light on the ground, until their natural cooling and then stored to its original position.

Notes
1, post-combustion furnace charge unplug the power cord as soon as possible to avoid over-heating caused by oxidation, corrosion or broken wires.
2, pulled out the ignition rods can not hang hold, hang, shaking, impact, or immersed in water cooling.
3, handle the internal circuit board with stainless steel rod connected with the grounding device or pin-out, please be sure to take the user to use, to ensure safety.
4, the ignition rod can not be used as heater, dryer use, is also not allowed to use the bathroom.
5, without the use of this product if damaged, as long as maintaining the status quo (stainless steel rod is not burnt black) by my company or warranty replacement.

Scope
Straw gasifier fuel ignition, briquette stove fuel ignition, charcoal ignition, kang material ignition, heating furnace charge ignition