RJ-45 Lightning Protector

Model:	VX-LPRJ45E
Brand:	DSLPartners/VersaXpress/Versatek
Origin:	Made In China
Category:	Electronics & Electricity / Telecommunication & Broadcasting / Network Communications Equipment
Label:	Lightning Protector , RJ-45 Protector , Lightning
Price:	-
Min. Order:	-

Inquire Now

Product Description

The VX-LPRJ45E/DP-LPRJ45E is designed to protect signal transmission on a Ethernet line if struck or exposed to lightening while safeguarding equipment from damage by surge induced over voltage.

Technical Parameters:

Type	VX-LPRJ45E/DP-LPRJ45E
Interface type	RJ45
(Un) Rated operational voltage	110V
(Uc) maximum operational voltage	170V
Nominal discharge current, In (8/20uS)	10KA
Maximum discharge current, Imax (8/20uS)	20KA
(Up) Measured limiting voltage	250V
Center Pass-through Frequency, MHz	20
Input Return Loss, db	≤ 0.2db
Protection Class	IP20
Size, mm	70x25x25 mm

Installation and Maintenance:

a. Installation diagram:

b. The VX-LPRJ45E/DP-LPRJ45E is connected in series at the front-end of the protected equipment. The input of the lighting protector is connected with the Ethernet line and the output should be connected with the input of the protected equipment.

c. The yellow wire is designated to be grounded.

d. The VX-LPRJ45E/DP-LPRJ45Edoes not require special maintenance to operate. Please inspect and remove the unit if it has failed. A replacement will be needed if the protected device is operating after removal and bypassing of the VX-LPRJ45E/DP-LPRJ45E.

e. It is recommended to verify the working condition of the units before and after any bad weather. If the until fails, please contact us immediately.