Attention:

1. The manual push rod at the end may be used during hydraulic system testing, with automatic reset functions.

2. For installation, use screws with a tensile strength of greater than 85kg/mm2 (Available at the time of purchase).

3. Inlet O-Ring must fully comply with Gb1325-76 Standards.

4. Remove the cover, tightenm it again after wiring to the base. There is a rubber ring at the cover wire entrance, when the threaded cover is tightened, wiring in the plug will be tightly clamped.

5. Cable must comply with explosion-proof requirements

 

Technical specification

 

Model dMFZ-37-MA dMFB-37-BT4 DTBZ90FYC-MAI

Rated Voltage DC: 12V. 24V. 48V

B: 48V(Input Voltage: 110VAC)

B: 99V(Input Voltage: 220VAC) DC: 12V. 24V

Rated Travel (mm) 2.8 2.8 4

 

Toal Travel (mm) 6 6 <9

Attraction Force (N) >37 >37 >90

Power (W) 22 22 36

Nominal Fluid Pressure (MPa) 10 10 21

Connection Dimension (mm) &phi;19? . 5 &phi;19? . 5 &phi;32?

Installation Dimension (mm) 35? 5 35? 5 49? 9

Application Under-well or on-the-

Ground inflammable,

Explosive locations On-ground inflammable,

Explosive locations

Pilots for proportional direction

Control valves, proportional

Press. Control valves in explosive

And inflammable location