MegaLink spread spectrum microwave communication products to complete more than the base group of signals, or Ethernet signals through a wireless means to achieve point to point (Point to Point) of the relay transmission. E1 interface to its recommendations in full compliance with CCITT G.703 requirements, LAN interface complies with IEEE 802.3 protocol standard RJ45 interface. MegaLink microwave communication equipment, the total transmission rate of 8.448Mbps/16.896Mbps, transmission capacity for the 4E1, 4E1/LAN, 8E1, and 8E1/LAN. The device can be used for telecommunication networks based on E1 interface to the network connection and relay transmission can also be used to transfer data, images, voice and other integrated services, but also as a computer local area network interconnection bridge device can be widely used in telecommunications, computer network and military communications. 

MegaLink means to achieve a microwave and fiber optic, cable and other cable transmission exactly the same feature, which can replace the optical fiber, cable and other wireline access methods, in some special occasions, such as: crossing the mountains, wetlands, rivers, islands, or other special region, It is the best communications solution. 

The product uses an advanced application specific integrated circuit, programmable devices and microprocessors, improved equipment, integration and reliability. Duties of equipment and status monitoring capabilities would facilitate the user's engineering installation, maintenance and equipment management. 

MegaLink spread spectrum modulation unit from the microwave communications equipment and radio frequency modules. Modulation unit to achieve 4E1/8E1 data, logistical data and monitoring data, then the sub-multiplexer, digital spread spectrum, QPSK modulation and demodulation, etc. baseband signal processing, and the formation of 70MHz IF signal. RF module will be modulated cell 70MHz IF signal sent to the firing frequency band by the power amplifier output, while receiving antenna signal down-conversion to the IF signal into the modulation unit despread demodulation processing. RF unit is by a pair of frequency division duplex (FDD) component of the transceiver.