FE1/10(100)BaseT converter adopts telecom line (E1 or E1 transmitting network such as PDH, SDH, microwave, etc) to extend Ethernet. It converts Ethernet frame structure to E1 frame structure, and recovers E1 frame structure to Ethernet frame structure at the other side, which enables Ethernet data to transmit in telecom network based on E1. Because it is efficiently and effectively used the spared bandwidth of telecom providers, it saves the networking cost and improve the efficiency and can be used immediately.

1. Technology Characteristics of 1*FE1/10(100)BastT

Support Ethernet data transmitting transparently or according to timeslots in E1 line; bandwidth ranges from 64Kbps-2048Kbps
Support Ethernet auto-sensed and full/half duplex function
Support MDI/MDI-X auto-sensed
Support to transmit of extra long frames regulated by IEEE 802.1Q; support Ethernet switch with VLAN function
Support data filter at local side
Provide unbalanced 75 and balanced 120 E1 interfaces

2. Interface Parameters of 1*FE1/10(100)BastT
2.1 E1 Interface:
Support ITU-T G.703 , G.704
HDB3 line coding, comply indication output of route warn
Coding rate : 2048Kbps50ppm
75 physics interface use BNC standard coaxial connector, 120 physics interface use RJ45 connector
2.2 Ethernet Interface:
Fully IEEE 802.3 (2000) compliant
Bit rate: 10Mbps or 100Mbps
Interface type: RJ45

3. General characteristics of 1*FE1/10(100)BastT
Power : 220V20% , -36 ~ -72V
Power Consumption : < 5W
Environment Temperature : 0-50
Size : 22017535mm or48316045(mm)
Net Weight : 900g

4. Packing List of 1*FE1/10(100)BastT
FE1/10(100)BaseT Protocol Converter
One Power cord (Note : -48v no with power cord)
Two BNCs Coaxial Connector
Manual book

3-5 business days
3000pcs per month
T/T in adva