The TE110P is a single span, selectable E1 (32-channel) or T1 (24-channel) card that supports all the functionality of the Digium quad T1/E1 card. The card can be used to deliver a wide range of PBX and IVR services to the network or handset including Three-Way Calling, Call Conferencing,Voicemail ,and VoIP Gateways.

 

--Creat a wide range of ISDN PRI PBX

--ISDN least cost router
--VoIP integration of ISDN equipment

--Call center

--Single span E1/T1/J1 card

-- ISDN PRI protocol

--Support SS7

--PBX to PBX trunking

--VoIP Gateways

--IVR services
--Three-Way Calling
--Call Conferencing

--Voicemail

 

-- The TE110P is a single span, selectable E1 (32-channel) or T1 (24-channel) card that supports all the functionality of the Digium quad T1/E1 card.

--The TE110P supports both voice and data modes on its single span. For example, the card can support 12 channels dedicated to voice and 12 to data while passing all traffic through to the Asterisk PBX, which reliably routes the channels to their designated locations. This eliminates the need for an external router.

--By utilizing our TDMoE technology, an exclusive Digium process, one can easily connect multiple PCs equipped with the card and achieve voice quality on par with single PBX implementations.

--Scalability for this product is derived from adding multiple cards to each individual PC. Add addition cards as you need them for your expanding applications.

--The card supports industry standard telephony and data protocols, including both RBS and Primary Rate ISDN (PRI) protocol families for voice and PPP, Cisco HDLC, and Frame Relay data modes. The board drives both line-side and trunk-side interfaces, including call features.

--The card is a compact and powerful interface supporting voice and data transmission over T1, E1, and Primary Rate ISDN (PRI) connections.

--The TE110P is a low profile, half-length PCI form factor allows this device to fit within a 2U rackmount case or equivalent chassis, offer excellent density for call center, service provider, and other space-sensitive applications.

--The TE110P is fully supported by Digium open source Asterisk PBX software.Used in conjunction with Asterisk, the card offers the power to create a seamless network, interconnecting PSTN with the emerging Voice-over IP technologies.

 

1)configuration & interface
--1 X E1/T1 interfaces ( E1/T1 selectable)
--PCI 5.0V interface
--One PRI port 30 channels
--Hardware DTMF detection
--Conference Bridge
--PCM bus connectors (PCM30, PCM64, PCM128)
--4 dual-color LEDs (layer 1 state indicators)
--Active channel switching (across multiple cards over the external PCM bus)
--PRI ISDN protocol stack
--Suitable for 3.3 volts and 5.0 volts 32 bit PCI 2.2 slots

2)Data Modes
--Cisco HDLC
--HDLC
--PPP
--Multilink PPP
--Frame Relay
3)Voice Modes:
--PRI CPE & PRI NET

 --NI1
--NI2

--EuroISDN
--4ESS (AT&T)
--5ESS (Lucent)

--DMS100

4）E&M
--Wink
--Feature Group B
--Feature Group D
5）FXO & FXS
--Ground Start
 --Loop Start
--Loop Start with Disconnect Detect

6)dimension&weight

--Size(mm): 122*63.5*18mm      

--net weight:80g  

--Package material:paper box

--Package Size(mm) : 210*140*30mm

--Gross Weight(g):140g