-     Miniature size 42.3mm*42.3mm*13.5mm

-     Fit onto motors seamlessly

-     Die-cast aluminum enclosure, improving heat transfer and durability

-     Wide supply voltage range 12 ~ 40VDC

-     Output current 4/8A, instruction adjustable

-     Full to 16th micro-step resolution

-     Dual full H-bridge with PWM constant current control

-     Accurate micro-stepping and current control, 6600 RPM max speed for NEMA 17 motor (half-step) and 4000 RPM for NEMA 17/23 motor (quad-step).

-     RS232 three-wire serial communication

-     Max baud rate 57600 bps

-     Embedded 64-bit calculation precision high-performance digital signal processing micro controller

-     Absolute position counter, reset by instruction or sensor input

-     Advanced motion control module, from 0 to 4000 RPM in 0.25s and from 0 to 6600 RPM in 0.5s (for NEMA17/23)

-     2 sensor input ports, can be configured as 2 digital or 1digital 1 analog input ports（12bit）

-     8 programmable real-time event-based change notifications (similar to interrupters)

-     5 programmable actions triggered by 6 sensor events

-     Simple, intuitive, rich instructions

-     User-friendly interface

UIM24104 and UIM24108 are miniature stepper motor controllers with RS232 interface. User device can command these controllers through RS232 using ASCII coded instructions. Instructions are simple, intuitive and fault-tolerating. User is not required to have advance knowledge on stepper motor driving.

UIM241 controller’s architecture comprises communication system, basic motion control system, absolute position counter, and real-time event-based change notification system. Embedded 64-bit calculation precision DSP controller guarantees the real-time processing of the motion control and change notifications. 

There are 2 optional advanced modules for selection: Advanced Motion Control Module and Input Control Module. With UIM241’s Advanced Motion Control, selected NEMA 17/23 motors can ramp up to 6600 RPM in 0.5 seconds and 4000 RPM in 0.25 seconds (online video available for downloading). 

UIM241 controllers can be mounted onto NEMA17/23/34/42 series stepper motor through adapting flanges. Controller thickness is less than 14 mm. Enclosure is made of die-cast aluminum to provide a r ed durable protection and improves the heat dissipation.