UST101T Single Channel Active UTP CAT5 Video Transmitter
1000-4000ft　 Lightning Surge Protection / Figure Enhanced Model

Introduction
UST101T UTP CAT5 Video Transmitter is an active (amplified) device that allows the extension of real-time monochrome or color video on up to 4000ft ,using Category-5 Unshielded Twisted-Pair (UTP) CAT5 networking wire. Baseband (composite, PAL/NTSC/SECAM) signals of any type are supported.

The unparalleled interference rejection and low emissions of the Model UST101T & UST101R allows long run video signals to co-exist in the same wire bundle as telephone, datacom, or low-voltage power circuits. This allows the use of shared or existing cable plant. Ground-lifting ensures no annoying "hum-bars" when ground potential differences exist. With built-in lightning protection,transient protection, ESD protection,damaging voltage spike problems are eliminated.

Equipment Specifications

Cable Distance：Up to 4000ft, UST101T+UST101R UTP CAT5 or better.

The transmission of real-time PAL, NTSC or SECAM video signals.

Image figure enhanced in output of UST101BR UST101CR Receiver.

Lightning protection, Transient protection, ESD protection, damaging voltage spike problems are eliminated.

Dimensions excluding BNC: 92mm×61mm×22mm.

Technical Specifications

VideoFrequency Response　　DC to 6 MHz.

Distance Switch　4-Position Adjustable.

Common-mode / Differential-mode Rejection　15KHz to 5 MHz　60 dB typ.

Line Impedance

Coax, female BNC　75 ohms.

UTP, Terminal Block　100 ohms.

Wire Type

Network Wiring　2 Unshielded Twisted Pair 24-16 AWG (0.5-1.31mm).

Category Type　Cat 5 or better.

Impedance　100 ± 20 ohms.

DC Loop Resistance　52 ohms per 1,000 ft (18 ohms per 100 m).

Differential Capacitance　19 pF/ft max (62 pF/m max).

LED Indicators

Power On　　Red Indicator Light.

Video Signal Present 　Yellow Indicator Light.

Power Supply Range

Transmitter/Receiver: 9-12V AC/DC (MAX 24V AC/DC) DC/AV 9-12V　500 mA 　MAX (24VAC/DC).

Environmental

Temperature 　0°C to +50° C.

Humidity (non-condensing)　0 to 95%.

Transient Immunity

6,000 V　1.2μS x 50 μS per ANSI/IEEE 587 C62.41 B3.
3,000 V　8μS x 20 μS when ground screw terminal is bonded to earth-ground.

Installmen

1:Put the video signals you need in the VIDEO IN of UST101T.
2: Put a twisted-pair in the VIDEO A, B of UST101R.

3: Connect with the mains following instructions shown in the sketch map, make sure that the power should be between DC/AC 9 to 24V. Recommend work in DC 12V.
Recommend to share 12V DC power supply with camera in transmitter termination.

4: Set the position of ADJ correctly according to the distance table in UST101T & UST101R sub-surface.

5: After the four steps, the VIDEO output of UST101R is ready to work..

Check After Connection

1. Power On 　　　　　　　Red LED Indicator Light.

2.Video Signal Present 　　Yellow LED Indicator Light

3. Make sure that every wire is correctly and firmly connected.

?

Mechanical

Dimensions excluding BNC 　92mm×61mm ×22mm.

Material　Metal

3 Year Warranty