Models with 4 weight 1.2 ( kg )

Size of 1 * 1 * 1 ( mm ) of China

Brand RT environmentally friendly packaging paper packaging

Tu 4 viscometer

Use

Apparatus for measuring viscosity in 30s-100s coating products, is a portable instrument, the viscosity of coating were measured, the measured liquid full, from the hole out of the time required for measurement, the viscosity of the liquid in seconds.

Main technical characteristics

Viscosity cup for the brass manufacturing, capacity of approximately 100 ml, bottom outlet hole is made of stainless steel.

K value in the set temperature conditions ( such as 20 degrees C + C ) with two standard oil with viscosity, flow over time should be in the range of 30s-100s, K value should be within K value for number 356

Brief description of structure

Viscosity cup placed in a level bubble cup ring, adjustable base level screw makes the blisters center now, undertake cup capacity of approximately 150 ml, for holding liquid with.

The use of brief description

Before the measurements or measurements after application of gauze dipped in solution viscosity cup with clean dry air, does not allow any residual liquid adhesion in a cup or outflow pipe orifice, should make the inner wall of the cup and the outflow hole clean.

Before the test, adjustment screw base level, make the blisters center.

The test solution was stirring, and in less than 567 holes / cm screen filter, control under the preset temperature, keeping the 15min measured after.

The test solution was injected into the viscosity cup with the fingers over or will switch the outflow hole, filled with glass plate at the cup mouth scraping flat surface, the excess liquid scraping into the viscosity cup edge groove, put undertake cup.

The finger open or switch, start the stopwatch at the same time, liquid outflow into lines until disconnect when stop and stopwatch, stopwatch readings is the measuring time, in seconds.

The two test, the error does not exceed

After each use