digital readout don not display

1.Whether the power kine is connected. 2.Whether the power switch is connected 3.Whether the power voltage si suitable 4.The inside power of the linear scale is short circuit
5.The safe pipe fusing or not.

1.Check the power line and connect it 2.Connect the switch 3.The power voltage should between 100V~250V
4.Pull out the connect of the linear scale.
5. Change the safe pipe

The hull of the digital readout has electrification

1.check whether the lathe and the digital readout landing well
2.whether 220V power is leakage of electricity

1.make sure the lathe and the digital readout landing well 2.Check 220V power

one axis does not count

1.Exchange the linear scale with anther axis,whether count 2.the digital readout is under some special function

1.if count normally,it is the stoppage of linear scale;if it does not count also ,it is the stoppage of digital readout 2.quit the special function

The digital readout does not count right,the distance displays is not the same as the actual distance

1.check whether the lathe and the digital readout landing well
2.the lathe has a low precision
3.The running speed is too fast of the lathe
4.the installof the linear scale is not up to standard.low precision

5.The resolution of the digital readout does not agree with the linear scale

6.The dimension unit does not agree with the mm/inch
7.the linear error compensation setting is not right
8.Reading head is broken down

1.make sure he lathe and the digital readout landing well
2.Repair the lathe
3.Slow down the speed
4.Install the linear scale as required

5.reset the resolution
6.change mm/inch

7.reser the linear error compensation
8.change linear scale reading head

The linear scale does not count or sometimes

1.Reading head is broken down
2.there is foul inside the linear scale
3. short circuit or open circuit inside

1adjust the install of the lathe and the linear scale,repair and change the linear scale
2.repair linear scale
3.repair linear scale

anti-jamming function is not well

1. check whether the lathe and the digital readout landing well
2whether the shielding line inputting connected well with the metal case

1.Make sure the lathe and the digital readout landing well
2connect again