Model: | HO-8H |
---|---|
Brand: | HONOW |
Origin: | Made In China |
Category: | Transportation / Car Accessories / Auto Repair Tools |
Label: | auto diagnostic tool , injector tester , vehicle diagnostic |
Price: |
-
|
Min. Order: | 1 pc |
Last Online:18 Dec, 2018 |
Main functions
● Can do reverse flushing, flush-back cleaning, ultrasonic flushing, and disaffiliation-free flushing to one or more fuel injectors
● Automatically simulate the overall process under various pulse width and engine speed. The operation status of the fuel injectors can also be observed whether at acceleration and deceleration.
● Can manually set time, pulse width and rotation speed of the fuel injector, and observe the performance under varied parameters. Ease and convenience of operation.
● Can determine the shortest on-off cycle and the quality of the injector.
● Can do oil circuit testing, and disaffiliation-free flushing to the engine.
● Ultrasonic cleaning: ultrasonic cleaning for the single or multiple injector, can thoroughly remove carbon deposition of injector.
● Uniformity test: test the uniformity of spray nozzle of oil.
● Atomization observation: using the background light, can comprehensive and careful observation of nozzle jet atomization.
● Leak test: injector can be detected under the high pressure of sealing and dripping.
● Fuel injection quantity detect: can detect nozzle under certain operating conditions (such as the same time, same timer) of fuel injection quantity.
● Automatic cleaning detection: under certain operating conditions, the actual simulation nozzle test under various conditions.
Ready to work
1) Remove the nozzle from the car, check whether the rubber sealing ring is damaged, if damaged, should be replaced in time before washing test, in order to avoid leaking test. Then nozzle into gasoline or detergent, carefully remove after the external pollution with a soft cloth to wipe clean.
2) Switch on power supply (note: this equipment is a long time after power restart, will delay for a few seconds).
3) From the parts cleaning bracket out of box, put into the ultrasound groove, and wipe clean the nozzle in the ultrasonic tank cleaning bracket positioning hole.
4) Link fuel injectors to pulse signal circuit, and place the injectors into the ultrasonic rinse tank. Add cleaning liquid into the tank (Normally two thirds of the tank), and switch on ultrasonic.
Technical parameter
Dimension: 63*61*74cm
Weight: 54kgs
Voltage: AC220V/110V±10%, 50/60Hz
Input power: 250W
Ultrasonic cleaner power: 100W,25KHz;
Operation Temperature:-10C°~40ºc
Tank Capacity: 6L
Test Tube Capacity: 120ml
Ultrasonic Frequency: 28KHZ±0.5 KHZ
Rotation Speed: 0~10000r/min
Step: 100r/min
Step: 60sec (adjustable)
Oil Pump Pressure: 0kg/cm²----6.5kg/cm²
Fuel Flow: 4.5 L/min