Home > Products > Electronics & Electricity > Electronic Instrument > Test Bench

TN3718  Handle Dynamic Strength Tester

INTRODUCTION

This machine is not only used for handle dynamic strength testing but also for handle dynamic durability testing .

TEST PRINCIPLE

Place the test mass in the reclined cradle centrally against the backret in such a way that its bottom edge is in contact with the seat/back junction line ;hold the test mass in place by means of restraining system or by any other means which do not affect the test result.The test mass can be wrapped in a protective cover to ensure that the seat fabric is not damaged during the test.

Suspend the reclined cradle by the carrying handles from the hooks,using the straps if required.Raise the metal plate and let it fall freely from a height of 100 mm onto the 4 rubber stops.After dropping the plate 10000 times at a rate of ten times a minute,remove the test mass and check the sample.

FUNCTIONS AND FEATURES

1. Unique design, reasonable structure and small footprint.

2. Easy to operate, fast and efficient.

3.The bottom is equipped with universal wheel, easy to move.

TECHNICAL PARAMETERS

1.Workstation : 1

2.Test frequency : 10 cpm,adjustable

3.Counting range : set from 0~999 99,the standard calls for 10000 times

4.Dropping height : 100±0.5 mm

5.Metal plate size : 300×300×6 mm

6.Standard rubber stops specification : Ф30 mm,15 mm high,70 shore A hardness

7.Distance between stops : 200 mm

8.Air source : 6 kg/cm2 or above stable air source (users provide)

9.Power supply : AC220V,50/60 Hz,300 W

10.Wight : 85 kg

11.Dimension : 115×51×166 cm

STANDARDS

BS EN 12790

Our products are all certified by international authority,national metrolog inspection center, won praise from customers all over the world ,including SGS,ITS,BV,TUV Sud,TUV Rheinland,CTI,etc

NEW TOTAL SOLUTIONS

HONOR AND CERTIFICATES

STANDARD PACKING

MULTIPLE TRANSPORTATION