XP-2A型双头高速线抛光机 
XP-2A Dual Heads High Speed Precise Wire Polishing Machine

该机为我公司引进西德修制模技术生产的，为抛光天然钻石拉丝模和聚晶拉丝模的各个区域和控制最终尺寸而精心设计的，该机具有二组独立而完整的工作装置。主要特点有：
1、 能同时抛光拉丝模的入口、定径、出口等各个区域，该机设计了模座角度0-20度可任意设定，同时又可以按设定的角度自动摆动，达到了节省时间，提高效益的目的。
2、 为了达到加工微丝模的要求（最小加工孔径为0.015mm的模具），该机又设计了可无级调速、长行程匀速的冲程线架和可无级调速的模座，具备了修造微丝模的基本条件。
3、 确保加工模具孔形的真圆度，该机又设计了稳定、高精度自定心的模座，从而提高模具的品质。
4、 降低劳动强度，提高效率，采用高精度的时间电路，数字设定，数字显示，直观方便。
5、 更好适应微丝模的修造，采用坚固稳重的机架，进一步提高设备在工作状态下的稳定性。
主要技术指标：
a.电源：220V 50Hz 550W
b.加工孔径范围：0.015~4.00mm
c.模壳最大直径：小于30mm
d.模座摇摆角度：0-20度
e.模座转速：0-1400转/分（无级）
f.冲程速度：0-300次/分（无级）
g.冲程幅度：80mm
h.定时时间：1秒~99分99 

 

A.      Introduction

The machine is for my company to introduce West Germany mould repaired technology, well-designed for polishing natural diamond wire drawing dies. polycrystal drawing dies and controlling the ultimate dimension. It has two independent and complete device. Main specification as follows:

1) Simultaneous polishing wire drawing dies entrance , diameter , exit and other areas, The mold base angle can be arbitrarily set within 0-20 degree, Moreover, it can swing automatically according to the angle setting up, have reached the purpose of saving time and improving efficiency.

2) In order to achieve processing minor dies requirements (dies minimum processing hole diameter is 0.015mm), the machine has also designed stepless speed regulation, the long route of uniform speed line-stroke shelf and stepless speed regulation mould base, equipped with the basic conditions for minor dies.

3) To ensure the degree of processing die's hole circle, it also designed a stable, high accurate self-centering mold base, thereby raising the dies quality.

4) Reduce labor intensity and improve efficiency, using high-precision timing circuits, digital set, figures show ,visual and convenient.

5) Easier to adapt to the minor dies produced and repaired, using the steady and firm stand , improves the equipment stability on the status of working.

 

A.     Main Technical Parameter

Power source                      : 220V  50Hz  550W

Processing hole diameter      : 0.015~3.00mm

Dies shell maximum diameter: smaller than 30mm

Mould base swing angle        : 0-20 degree

Mould base rotating speed     : 0-1400 revolution/minute (stepless)

Stroke speed                        : 0-300 times/ minute (stepless)

Stroke range                        : 80mm

Regular time                        : 1S~99M99S