山泉AM-111聚氨酯建築嵌縫密封膠　

SHANQUAN AM-111 PU Sealant for Constructional joint sealing

●產品描述Description

　　山泉AM-111為100%聚氨酯建築嵌縫密封膠，中性、濕氣固化,且固化過程無毒無味，與建築材料表面有良好的粘接力。具有良好的耐候性、彈性及耐低溫性能,耐水性、抗煙霧性強。

　　SHANQUAN AM-111 is PU sealant for constructional joint sealing. It is neutral and is cured by reacting with moisture in air. During the curing process，it won’t produce any poison and pollution on the base surface. It can adhere to constructional materials well. It has good resistance to elements、good elasticity、good low temperature resistance and good resistance to fog.

●技術數據Technical Date

●應用範圍Areas of Application

　　1.大理石、玻璃、鋁塑板幕牆等嵌縫密封。

　　2.內、外牆填縫、防水密封，採光天棚、建築伸縮縫、沉降縫的密封。

　　3.市政工程、排污管道的防水密封等，隧道及道路工程的混凝土伸縮縫密封，陶瓷工程的粘接及填縫密封。

　　1.Joint sealing of marble、glass、curtain and so on.

　　2.Sealing of inner 、outer wall， waterproof， lighting sunshade，dilatation joint and settlement joint.

　　3.Waterproof Sealing of municipal project、sewage conduit，sealing of dilatation joint of tunnel and road project，adhesion and sealing of ceramics.

●施工方法Method of Application

　　1.用棉紗清除塗膠部位表面的塵土、油污及明水。如果表面有易剝落鏽蝕，應事先用金屬刷清除，必要時還可用酒精、丙酮等有機溶劑擦拭表面。

　　2.根據施工部位的形狀將密封膠的尖嘴切成一定形狀的大小，用手動或氣動膠槍將膠塗在施工部位。

　　3.縫隙中鼓出的膠可用刮板刮平或肥皂水抹平。如有的部位不慎被膠所污染，則儘早用汽油或酒精等溶劑清除。如膠已固化，需要用刀片切割或打磨。

　　1.Cleaning away dust，greasy dirt and clear water of the glued surface by cotton yarn. If the surface contains rust，which should be in advance cleaned away by metallic brush， in addition to，can also wipe the surface.

　　2.The nozzle is sheared as required size and screwed on the sealant，then the sealant with the nozzle is used by the manually-operated or the compressed-Air pistol.

　　3.The superfluous sealant from the gap may be pared off by the pattern strickle or suds. It is necessary to be cleared away at once by using benzene if the rest part is polluted by the sealant. It is necessary to cut or burnish by knife if the sealant cured.

●包裝Package

　300ml鋁管Cartridge                           12支/箱

　400ml、600ml軟包裝Sausage                   20支/箱

　小桶Can                                     約23kg/桶

　大桶Drum                                   約230kg/桶

●貯存 storage

　　建議在25℃以下的乾燥庫房內，避免高溫/水汽，貯存期一般為9個月。

　　We s est the products should be stored in the dry place bellow 25℃，avoid high temperature and moisture. The shelf life is nine months.

●注意事項 Attention

　　1.開封后應當天用完，否則需嚴格密封保存；

　　2.在溫度15-35℃、濕度55%-75%RH條件下施工最佳；

　　3.當環境溫度低於10℃或出膠速度達不到工藝要求時，建議在60℃烘箱里至少烘烤30分鐘！

　　1.If the sealant is opened，it should be used up the same day；otherwise it should be conserved strictly.

　　2.The best work condition is at the temperature of 15-35℃ and at the degree of humidity of 55%-75% RH.

　　3.When the environment temperature is below 10℃，or extrusion below craft requirement，we s est sealant be roasted for 30min in the oven.