Foam platform ( hydraulic platform, two steps foaming thermal insulation pipe equipment, polyurethane insulation tube equipment )

The supply of foam platform - Tianjin Xu Di polyurethane anticorrosive insulation equipment limited company

Tianjin Xu Di polyurethane anticorrosive insulation equipment limited company to supply the foaming platform.

Hydraulic foam platform

The use of equipment: insulation pipe, steam pipe, heat pipe network.

Foaming platform as the two step process for producing polyurethane foam insulation pipe special auxiliary equipment.

Foam platform using hydraulic mechanism for placement in the equipment working table for bubble pipe ( already well middle bracket and an outer sleeve pipe ) ends quickly foaming flange connection, location, close to ban, for foaming operation. The device has high efficiency, low energy consumption, easy operation characteristics, greatly reduces the labor intensity of operating workers.

The machine is composed of left, right flange adapted, motion system; working table; hydraulic and control system etc..

1, flange adapted motion system:

Foam platform at each end of the oil cylinder pushes the flange plate a, by supporting wheel and a guide rod is matched and positioned to enable smooth motion. The pusher plate processing can be installed various types of foam flange groove ( hole ) and the flange is located on the push plate center to prevent stress tilt. Push plate oil cylinder installation guide rod and the seat board from both sides of the vertical guide groove, for the replacement of different specifications of the workpiece is adjusted to push plate center height adjustment by a chain interconnecting wire just to ensure the adjustment about synchronization. ( the handwheel for load adjustment, adjustment should be to push plate at near the screw hand wheel position ) when adjusting push plate flange with concentric and adjust the supporting wheel so that the push plate keep vertical state, to reduce the moving resistance.

In 2, working table:

Working table for steel plate and shaped steel welded structure, is divided into two sections, high strength, good rigidity.

Two ends each having two adjustable positioning block, so as to adjust the work direction and push plate flange concentric.

The bottom of the working platform to change working table tilt lifting mechanism, in order to tilt.

Foaming adjustment angle (such as dip for more than 5 degrees angle adjustable pivot end adjustment in digging pit ).

In 3, the hydraulic control system:

Both ends of the push plate - 63 / 45E head round flange connection, single earring type oil cylinder driving cylinder thrust force, 49.88kN ( 5T ).

Bottom lifting oil cylinder for two 80 / 45, each cylinder thrust for the 80.42kN ( 8T ).

Hydraulic system working pressure of 16MPa, when the pressure meter shows the pressure is not normal, overflow valve to make corresponding adjustments. Each cylinder consists of 3 manual reversing valve control.

The company engaged in steel tube hydraulic foam platform, quality assurance, welcome to consult.