Output wavelength:635nm

 
 
 Output power: 100mw-150mw
 
 
 Spot ovality> 0.9
 
 
 Light height 15mm
 
 
 Divergence angle <1.8mrad
 
 
 Operating Temperature 0 to 40 
 
 
 The modulation mode TTL level: (0 ~~ 20K)
 
 
 Input voltage: DC / AC 12V
 
 
 Laser Size: 55 (L) X30 (W) X30 (H)
 
 
 

Similar product recommendation

 

Fine spot:

 

R100       650nm(100mW-150mW)---------$28/pcs   

 

R300       650nm(300mW-320mW)---------$68/pcs   

 

R500       650nm(500mW-500mW)-------$148/pcs   

 

R1000    650nm(1000mW-1100mW)----$350/pcs   

 

RL100       635nm(100mW-120mW)---------$48/pcs   

 

RL200       638nm(200mW-220mW)-------$59/pcs   

 

RL500    638nm(450mW-500mW)--------$120/pcs      

 

RL800       638nm(800mW-1000mW)-------$355/pcs   

 

R1.5W   635nm(1600mW-1800mW)----$955/pcs   

 

Crude spot:

 

R200C       650nm(200mW-210mW)---------$35/pcs   

 

RL100C      638nm(100mW-110mW)---------$68/pcs   

 

*If you buy more than 30pcs, you can contact us e-mail request a new quote.

Instructions for use:
Plug in the power plug and then turn on the switch. Energized after 10 minutes of power into a stable state. Switching power supply should be more than 5 seconds interval, or fragile laser.
2. Use the power board should be placed on an insulator or overhead, or roasted bad laser power. The laser and the power cable at the same time not let received a large external force, so as to avoid the lasers internal cable disconnection.
3 for laser cooling, place the laser fixed on a flat metal plate.
The Note. Dust, not much of a place in the dust, if the laser is not a long time in the light hole at Paste dustproof paste.

Note:
1 laser and power should avoid the the strongly collision and vibration.
Do not direct laser irradiation to the human and animal body, especially the eyes, and light-sensitive organ, or likely to cause injury.
Do not dismantle lasers and power, where unauthorized demolition is not within the scope of the warranty of the Company.