Wavelength (nm) |
638nm |
Output Power (mW) |
>1600mW |
Input Voltage (V) |
90VAC~240VAC |
Operating Mode |
CW |
Cooling Mode |
TEC |
Transverse Mode |
Near TEM00 |
Beam Diameter at the Aperture (mm) |
~ 6 x 6mm |
Divergence , Full angle (mrad) |
<4mrad |
Power Stability (RMS/4 hrs) |
<5% |
Operating Temperature |
10~340dgC |
TTL |
0-30kHZ |
Laser Head Dim |
|
Expected Lifetime (hours) |
>5000 hours |
Package |
Retail Box |
*Modulation is: TTL or analog please leave a message or send e-mail
If there is no message, the default mode: TTL
Power Supply: 80 -260VA or 12VDC
If there is no message, the default mode: 80- 260VA
Similar product recommendation
Fine spot:
R100 650nm(100mW-150mW)---------$28/pcs
R300 650nm(300mW-320mW)---------$68/pcs
R500 650nm(500mW-500mW)-------$148/pcs
R1000 650nm(1000mW-1100mW)----$350/pcs
RL100 635nm(100mW-120mW)---------$48/pcs
RL200 638nm(200mW-220mW)-------$59/pcs
RL500 638nm(450mW-500mW)--------$120/pcs
RL800 638nm(800mW-1000mW)-------$355/pcs
R1.5W 635nm(1600mW-1800mW)----$955/pcs
Crude spot:
R200C 650nm(200mW-210mW)---------$35/pcs
RL100C 638nm(100mW-110mW)---------$68/pcs
*If you buy more than 30pcs, you can contact us e-mail request a new quote.
Instructions for use:
Plug in the power plug and then turn on the switch. Energized after 10 minutes of power into a stable state. Switching power supply should be more than 5 seconds interval, or fragile laser.
2. Use the power board should be placed on an insulator or overhead, or roasted bad laser power. The laser and the power cable at the same time not let received a large external force, so as to avoid the lasers internal cable disconnection.
3 for laser cooling, place the laser fixed on a flat metal plate.
The Note. Dust, not much of a place in the dust, if the laser is not a long time in the light hole at Paste dustproof paste.
Note:
1 laser and power should avoid the the strongly collision and vibration.
Do not direct laser irradiation to the human and animal body, especially the eyes, and light-sensitive organ, or likely to cause injury.
Do not dismantle lasers and power, where unauthorized demolition is not within the scope of the warranty of the Company.