Model：Chinafix CF360T

Solder Type：Lead/Lead free

SMD Type：Micro bga,BGA,CSP,QFP

PCB Thickness：0.5mm~4mm

PCB Size：W50*D50~W455*D350mm

Heating Mode/Power(Upper)：Hot-blast air /800W

Heating Mode/Power(Bottom)：Hot-blast air /800W

Preheating Mode/Power：IR 2400W

PCB Location Mode：Shape or Tongs

Drive Mode：Gear,Rack

Control/Adjusting Mode：Touch Screen + PLC

Temperature Range：Room Temperature 0~400°C

Max Power：4000W

Supply Voltage：110V /220V

Machine Dimension：760mm(L) * 700mm(W) * 600mm(H)

Machine Weight：36KG

CF360T  characteristic:

 Intelligent Mute, Pre-warning when curve end up, precise temperature-control, operation audio-visually

1, The hot-air part adopts exported long-life heating coil, through special insulation heating treatment, heating uniformlier, long-life to use well.

2, The design of three warm area support, can fine adjust to support height, avoid welding-area to sink.
3. The upper hot air-flow can be adjusted,  use different air-flow to different chips, preciser temperature, it's not easy to make expand.

4, Overtemperature protection function,over the temperature, heating coil automatic power off.

5, Intelligent mute function, keep mute under non-working condition.

6, New type design of air outlet with mixed wind, air-out temperature uniformilier.

7, Machincal part adopts oxidation treatment, main machine box use thicken material, prevent shapeless at whole hog.

8, Upper heating part continue to use high-grade products' design of move by X/Y shaft, treating all kinds of shapeless chips easiler.

9, Three warm areas can be controlled separated, to achieve the function of soldering and dry.
10, Complete machine construction adopts the only design of dismounting easily, exchange electric parts simply and conveniently, warranty with fast speed, machine's rate of utilization reaches the highest.

11, Allocate vacuum attaching-pen, automatic start when ending heating, take down chips easily.
12, Warning function on the peak temperature, warn before ending up curve heating 30s ago, conveniently manual interveniton.
13, Warn when ending the curve.

Warranty Policy:

1. We guarantee 1 year of warranty for all machine parts. But not contain the exterior broken. Touch screen, PLC are all guaranteed for two years’ warranty. Guarantee five years’ cost-repair.

2.We can pay all the freight during warranty time( Only to the clients in inland, China. The international freight should be responsable by clients).

3.If there is something wrong about screen and PLC, you need send back the bad parts to our factory in advance, to let’s check and confirm it, then we can send you the good ones. About the other parts with any fault, we can send a good part to you first, then you send the bad one to us or no need again.