ENDLESS FLAT CONVEYOR BELT

 

Characteristic:

Endless conveyor belt is a kind of conveyor belt without any joint point.As it obvious feature is no joint point,it will not 

affect the life of the belt in usage.The surface of the belt is smooth,and the tension is in average,as a result the belt can 

work steadily with a small pull rate.

Construction of our rubber conveyor belt

1.        EP fabric Carcass( Warp is polyester and weft is polyamide)

2.        NN fabric Carcass( Warp and weft both nylon)

3.        Steel cord (ST630-ST6300)

4.        Special rubber layer with good fabric adhesion properties( skimmed layer)

5.        Cover rubber( special quality requirement)

Advantage of our conveyor belting

1.        Light weight, thin

2.        High elasticity

3.        Impact resistant

4.        Low elongation

5.        Good flexibility and good through ability

6.        High abrasion

Application of our conveyor belt

1.        Cement, concrete plants, bulk handling

2.        Coal, mining, sand, gravel, stone crusher

3.        Steel industry, heating and power

4.        Road construction machinery, etc

Conveyor belt specification

Fabric type	Fabric structure		Fabric type	Fabric thickness	Cover rubber thickness		Width	Length
	warp	weft			Upper	Lower
EP	EP	EP	EP-100	0.75	1.5-8	0-4.5	400-2500	<=300/roll
			EP-150	0.8
			EP-200	0.90			500-2500
			EP-250	1.15
			EP-300	1.25
			EP-400	1.45			800-2500
			EP-500	1.55

 

 

 

 

 

 

Conveyor belt technical data sheet  

We could offer conveyor belt with cover grade in accordance to International standard such as DIN 22102, RMA, AS 1332, SABS 1173/2000, IS 1891, BS 490, JIS K 6322, etc

Standards	Cover Rubber			Adhesion
	Tensile Strength	Elongation at break	Abrasion	Cover to Ply	Cover to Ply	Ply to Ply
DIN 22102	Mpa	%	mm3	N/mm   (≤1.5mm)	N/mm   (>1.5mm)	N/mm
DIN 22102-Z	15	350	250	3.5	4.5	5
DIN 22102-W	18	400	90	3.5	4.5	5
DIN 22102-Y	20	400	150	3.5	4.5	5
DIN 22102-X	25	450	120	3.5	4.5	5

 

Standards	Cover Rubber			Adhesion
	Tensile StrengTD	Elongation at break	Abrasion	Cover to Ply	Cover to Ply	Ply to Ply
AS 1332	Mpa	%	mm3	N/mm   (≤1.9mm)	N/mm   (>1.9mm)	N/mm
AS 1332-N17	17	400	200	4	4.8	6
AS 1332-M24	24	450	125	4	4.8	6