Model: | PT-10 1008 |
---|---|
Brand: | Photel |
Origin: | Made In China |
Category: | Electronics & Electricity / Telecommunication & Broadcasting / Other Communication Equipment |
Label: | E1 OVER ETH , ETH TO E1 , E1 TO ETH |
Price: |
US $260
/ pc
|
Min. Order: | 2 pc |
PT-10 1008 E1 signal over Ethernet Protocol Converter
1.Brief Introduction
The 8E1 TDMoIP is the new generation of the TDM over IP equipment with IP circuit emulation that supports transportation of 8 E1 and two local Ethernet ports over Ethernet or IP network. The uplink ports and user data ports are IEEE 802.3 compliant, 10/100 BaseT auto-sensed Ethernet port.
IP encapsulation adopts UDP format, which supports inner transmission in Ethernet network, and also supports route exchange transmission among network segments. The transmitted E1 can be framed or un-framed format, the E1 interface of the same TDM over IP equipment can be connected with the different remote TDM over IP equipment.
2.Main Features
Providing up to 8 E1 interfaces; |
Providing 4 ETH interfaces, herein 2 ETH interfaces are uplink interfaces, and the other 2 ETH interfaces are downlink service interfaces; |
Providing Optical ETH uplink interface; |
Having the high transmission efficiency, and the transmission delay can be adjusted; |
Supporting point to point, point to multi-point transmission; |
Supporting E1 framed, unframed setting; |
Supporting E1 loss alarm indication; |
Adopting UDP encapsulation, and supporting different types of Ethernet transmission channels; |
Supporting Ethernet PING package function; |
Ethernet supports 10/100M self-adaptive,half/full duplex self-adaptive; |
Supporting E1 package QOS assurance; |
The equipment firmware and software supports remote update function; |
Dual power protection, support AC220V or DC-48V(optional). |
3.Equipment Models
Model | E1 Number |
PT-10 1001 | 1 |
PT-10 1002 | 2 |
PT-10 1004 | 4 |
PT-10 1008 | 8 |
4.Technical Specification
Item | Description |
E1 interface | Bit rate: 2048Kbps ± 50ppm
Code type: HDB3 code,accord with G.703 standard
|
Ethernet optical interface | Bit rate: 150Mb/s ± 50ppm
Output optical power: ≥-15dBm Receiving sensitivity: ≤-35dBm Optical wavelength: 1310nm/1550nm Optical interface connecter: SC/FC |
ETH interface (10/100M UTP) | Bit rate: 10/100 Mbps half/full duplex adaptive
Standard: Compatible with IEEE802.3, IEEE802.1Q (VLAN)
|
ETH interface(100BASE/FX) | Bit rate: 100Mbps,full duplex
Standard: Compatible with IEEE802.3,IEEE802.1Q (VLAN)
|
Mechanical Dimension | Dimension: 440mm(Width)×270 mm(Height)× 44mm(Depth)
Net weight: 4kg |
Power Supply | Input voltage: Standard value -48VDC or 220VAC
Voltage range: -36VDC~-72VDC,176VAC~264VAC
|
Operation Environment | Working temperature: -10°C ~ +50°C
Working humidity: <=90%(no condensation) |
5.Typical applications
1.Point to point network
2.Point to multipoint network
6.Configuration and function
6.1Front panel
6.1.1.LED indication
lPWR: it is power supply indicator light, it will be green when power supply works normally;
lRUN: it is system indicator light, it will be green when system works normally;
lNMS: it is NMS indicator light, it will be green blinking when transmission NMS data;
lALM: it is alarm indicator light, it will be red when any 2M loss.
6.1.2.NMS interface
PT-10 100X TDM over IP Equipment has two types of NMS interface: ETH NMS interface and RS232 NMS interface, through these two types of NMS interface can only management local equipment.
6.1.3.ETH interface
PT-10 100X TDM over IP Equipment has 4 ETH interface, therein ETH-1, ETH-2 are downlink interface; ETH-3, ETH-4 are uplink interface. ETH-3, ETH-4 interface can be used to NMS interface, user can management remote equipment through these two interfaces.
6.1.4.Optical interface
User can configure ETH-4 interface to optical Ethernet interface through NMS, transmission through optical interface.
6.1.5.Power switch
Power switch: ON to turn on, OFF to turn off.
6.2Rear panel
6.2.1.Power interface
PT-10 100X TDM over IP Equipment supports two types of power supply mode: 220VAC or 48VDC.
6.2.2.E1 interface
PT-10 100X TDM over IP Equipment has up to 8 E1 interfaces, the E1 interface bit rate is 2.048Mbps, supports E1 frame,non-frame setting, it compatible with ITU-T G.703 standards. The connectors adopt unbalanced 75 ohm connector.
Certifications
Our Services
♦Payment
1.T/T by bank is our preferable payment method.
2.We also accept different payments,such as L/C, Western Union or as your demand.
3.We will send you our bank information in the PI, please note.
♦Shipment
1.Lead time based on our strong production capacity,normally one product can be ready within 1-3 days, if the quantity of the order is more than 500pcs,maybe we need a little more time.
2.Big order could be by sea or air.
3.We will send you in 3-5days after the full payment has been confirmed.
4.please provide your information:contact person name,company name,address,post code and telephone number in the PI.
♦Warranty
1.All products have been checked and packed in good condition after our serious QC test. If you have any question, please feel free to contact us, we would get it solved in limited time and our service would make you trust us.
2.Our equipment provide two years warranty, after two years you can renew the warranty.
♦Feedback
1.Hope we can have a long term cooperation.
2.We answer all your inquiries in 8hours or less guaranted,if you have any question about communication product please contact us.
3.If need our technical section will design solution for you.
4.We own the best after-sale service, our team will do our best to solve for customer when have any problem happen.
♦Contact us
E-mail:zyq@photel.com.cn
SKYPE:+8617712860139
Photel Communication Technology Co., Ltd | |
---|---|
Country/Region: | Jiang Su - China |
Business Nature: | Manufacturer |
Phone: | 17712860139 |
Contact: | Alex (Sales) |
Last Online: | 03 Apr, 2018 |