Product Name:5.8G Microwave Motion Sensor

 

Model:HFS-AC12

Input Voltage: 110V(90-165V) / 220V(180-265V)

Load Power:5A Relay, 1000W for  incandescent light, 500W for LED Light theoretically.

Sensing Distance: ≥ 12m

Sensing Angle: Right Cone 360 degree

Hold time: 2-120s   adjustable

Light Sensitivity: 0-Max  adjustable

Working Temperature:-10℃～+60℃

Life Span:＞16000H

The Factory Test Standards:

 

Module finished with 220V voltage test to meet the following requirements:

 

Frequency:5.8G   ±75M

5 pcs 100w ordinary incandescents paralleling load ( load power 500W) work properly;

Put it on the side position with 1.5 m height, the front sensing distance is more than 12 m;

Working properly for three hours in the oven with 60 degrees (more than 30 times per hour triggered)

5, Working properly under the circumstances below minus 10 degrees for three hours (more than 30 times per hour triggered);

 

Application：

 

This product is 5A relay output , basically applicable to all the lamps on the market , but the lamp with different size work by different loading power, such as incandescent lamp can load up to 1000W, LED light power and other inductive or capacitive load is generally less than 200W.

Output:L’.N connect with lamp load

Input:L.N connect with 220V   Nullline and Live wireinput

Output:L’.N connect with lamp load

 

2,Function Adjustment

Distance Adjustment:Adjusting the arrow clockwise to the upper left corner for the maximum distance (more than 12M), otherwise the nearest (0.5M or so), the middle can be adjusted freely (non-linear)

Time adjustment:Adjusting the arrow clockwise to the upper left corner for the longest delay time (120s), otherwise the shortest(2s), the middle can be adjusted freely linear

Light Controlling Adjustment: Adjusting the arrow to the upper left corner for the working mode of the whole day (no light controlling function), transferring to the upper right corner for the evening working mode

Attentions:

1. the module is not suitable for putting together with any high-frequency electronic equipment (within 30cm), keeping it from metal objects in its front side when working, vibration and any object with continuous action are forbidden within the induction scope of the module , otherwise own continuous trigger would be caused.

2, Being placed on a large area of metal objects or on the ground, the embedded installation on the wall, All of them are likely to reduce the module sensing distance

 

Attentions:

the product is featured by the connection of a set of hardware and software technology, the user can not disassemble or change any of the inside components parameters randomly, if any requirement changed, please contact us in time.