This detector is designed using the principle of the human infrared spectrum and Doppler motion detection technology. With a special filter lens and advanced signal analysis technology, it can be used in a variety of places such as banks, warehouses, office buildings, homes, trucks, ships, garages, and more.

(1) Indicator Z2 (Red) :When the first power on, the red and green lights up for one second at the same time, and then start to alternately flash into self-check mode. Red and green lights off at most 30S exit self-test.

The red light is on when the infrared is triggered and data is sent to the host. (Can be enabled by the toggle switch).

(2) Indicator Z1 (Green) : When the battery is low, it blinks with a buzzer, about 1 minute/time.(Can be enabled by toggle the switch)

(3) Infrared alarm: when someone enters the detection area, it will trigger the infrared alarm and send alarm data to the host.

Note: The time interval for each alarm trigger is fixed, and an alarm can be generated after each set time. If there is a large personnel flow, it is recommended to set the alarm interval as large as possible to reduce power consumption. (Can be enabled by the switch).

(4)Anti-demolition alarm: After the anti-demolition button is pressed for more than 10 seconds, it will trigger the alarm.

(5) Low battery alarm: When the battery is too low, it will send a "low voltage alarm" to the host, and it will beep and flash green every 1 minute.

(6) Test alarm: After pressing the test button, the infrared will issue alarm information.

(7) Dip switch setting function.

 

Specifications:

Trigger Conditions: Tamper switch, low voltage, sensor

Infrared Sensor: Dual passive infrared pyroelectric sensor

Detection Range: Wide-angle lens Max. 12m

Detection Angle: 100° Wide angle lens

Alarm Interval: 10s/1min/5min/10min

Working Voltage: DC3V

Working Current: ≦30MA

Static Current: ≦25uA

Battery Life: 2 years

Working Temperature:-10℃ ~ +50℃

Relative Humidity: ≦90%

Indicator: infrared trigger, low voltage, charging state

RF Frequency: 433.92MHZ

Frequency Modulation Mode: ASK

Transmit power: 10db

Wireless distance: ≦120m (open area)

Dimensions: 107*57.4*37mm