With unique hot nozzle heating heating mode, single head and single head multipoint hot nozzle, single head of multipoint hot nozzle has vertical, horizontal, inclined Angle and linear arrangement of a variety of forms such as gate, with 2,3,4,6,8 into glue point and minimum center distance can reach the 13 mm, in addition to the applicable to general plastic, at the same time apply to play difficult engineering plastic, due to the heating elements heating power is low, in the process of production can be reduced more than 30% of power consumption, much reduced the production cost of products, is widely used in high demand of high precision packaging, medical, electronics, automotive and other industries.

1, 8, 10 mm in diameter according to the standard port, single nozzle injection quantity can reach more 2500 grams or less (relative to the weight of PP).

2 there are a variety of specifications to choose from, is divided into six series products: NT, NST, NSH, MV, MH, LN can be applied to single lumen or multi-cavity hot runner system.

3 good liquidity, accurate temperature control, gate is not easy to jam, superior to similar products abroad.

4 with replaceable type thermocouple J and 230 v heating coil.

5 uniform temperature distribution, heat quickly to the gate, note glue less pressure loss, bei molding cycle is short.

6 change color performance is good.

7 molding process temperature can be as high as 450 ℃.

8 is applicable to common plastic such as PE, PP, ABS, and is suitable for the PEEK, LCP and PA66 + 60% GF illiquid engineering plastics.