PARAM ^TM Heat Seal Tester seals the specimen to determine the seal parameters of basic film, laminated films, coating paper and other heat sealing laminated films according to the requirement of relative standards. The seal parameters include heat seal temperature, dwell time, and the pressure of heat seal. Heat seal materials that have different melting point, heat stability, fluidness, and thickness of could show various heat seal properties, which cause obviously different seal technique. Users can obtain standard heat seal index by HST-H3 Heat Seal Tester.
Characteristics
Micro-computer control; LCD display;
Manu interface, PVC operation board;
P.I.D digital temperature control system:
Underlying double cylinder simultaneous loop;
Two test start mode of manual and foot pedal;
Independent temperature control of the upper and lower heat seal head;
Various heat seal surfaces made to order;
Encapsulate even-temperature heating pipe by aluminum;
Rapid insertion and separation heating pipe plug;
Anti-scald design;
RS232 port;
Technical Indexes
Seal Temperature: room temperature~300ºC
Temperature Control Accuracy: ±0.2ºC
Dwell Time: 0.1s~999.9s
Dwell Pressure: 0.05MPa~0.7MPa
Seal Surface: 330 mm x 10 mm (also customize)     
Heat Type: Single heat surface or double heat surface
Gas Source Pressure: 0.05MPa~0.7Mpa (Users prepare gas source themselves)
Gas Source Inlet: Ф6mm polyurethane pipe
Dimensions: 536mm(L) x 335mm(B) x 413mm(H)
Power: AC 220V 50Hz
Net weight: 43kg
Standards

ASTM F2029, QB/T 2358(ZBY 28004), YBB 00122003
Configuration 
Standard: Mainframe, footswitch
Optional: micro-printer, micro-printer communication cable, software, communication cable.
Note: Gas source inlet isФ6mm polyurethane pipe; Users provide compressed air for themselves.