SPD for RJ11/RJ45

Model:	SRJ11H/SRJ45H
Brand:	RUILON
Origin:	-
Category:	Security & Protection / Other Security & Protection
Label:	surge arrester , surge protector , spd
Price:	US $10.9 / pc
Min. Order:	10 pc

Inquire Now

Product Description

Product About

Telephone signal surge arrestor is mainly used in the surge protection of all kinds of telephone wire, audio transmission line
and equipment interface. With over voltage and over current suppression unit installed inside and two levels connection circuit
protection design, the SPD can suppress surge voltage and current effectively. The product has applied the malfunction self-
recovery design, thus providing thorough protection for the signal and the appliance.
According to the definition of the partition of lightning protection, this kind of surge arrester can be installed on LPZ0A-2 or a higher interface, or it can be installed directly at the front-end of the protected equipment. It can be used for the surge protection of telephone system/ADSL and ISDN telecom circuit.

Technical Parameters

Type	SRJ11H
Nominal operating voltage	110V DC
Maximum continuous operating voltage	190V DC
Nominal discharge current	5kA
Maximum discharge current	10kA
Protection level	210V
Rates	10MBit
Response time	1ns
Protection ports	RJ11
Use environment temperature	-40°C ～ +80°C
Outer casing protection grade	lP20
Testing standard	GB 18802.21-2011
Installation mode	35mmDIN

Installation considerations

1，SPD shall be as close as possible to protect the equipment.
2，SPD grounding wire should be as short as possible and shall not exceed 1m.
3，When SPD fails ,internal short circuit or circuit breaker status occurs,then the protective equipment is unable to carry out normal line pass. In that case, SPD should be promptly replaced.
4，SPD is a one-time security device, whose damage cannot be repaired.

Product About

Network signal surge arrestor is mainly used in all kinds of video line and equipment port of surge protection. With over voltage and over current suppression unit installed inside and two levels connection circuit protection design, the SPD can suppress surge voltage and current effectively. This kind of surge arrester has applied the malfunction self-recovery design, thus providing thorough protection for the signal and the appliance.
Technical Parameters

Type	SRJ45H
Nominal operating voltage	5V DC
Maximum continuous operating voltage	8V DC
Nominal discharge current	5kA
Maximum discharge current	10kA
Protection level	27V
Rates	10M-100MBit
Response time	1ns
Protection ports	RJ45
Use environment temperature	-40°C ～ +80°C
Outer casing protection grade	lP20
Testing standard	GB 18802.21-2011
Installation mode	35mmDIN or Wall mount

Installation considerations

1，SPD shall be as close as possible to protect the equipment
2，SPD grounding wire should be as short as possible and shall not exceed 1m.
3，When SPD fails ,internal short circuit or circuit breaker status occurs, then the protective equipment is unable to carry out normal line pass. In that case, SPD should be promptly replaced.
4，SPD is a one-time security device, whose damage cannot be repaired.